SOURCE: dodge caravan 1997 3.3l Xavierfrancofuenmayor
Had similar problems occur on various Chrysler products manufactured since 1986. What I did was remove the computer from the car and then take a Dremel tool with wire brush attachment and lightly buff all the pins of the computer--tops, sides and backs. After this I then take a jewelers round file and insert the tip into each connector pin hole and very lightly file it to remove any corrision. When I reassembling the connector plug to the computer I placed a good size dab of silicon grease on the plug in the center (acts as a seal when seated). This has eliminated the problem on four different vehicles.
SOURCE: 1997 dodge dakota v6 engine wont start replaced
turn the key to the on position a see if you can here a buzzing sound around the fuel tank,if you don't hear a sound then. (be very careful while doing this) with the key off take a fuel line coming from the tank loose,make sure its pointed away from you and turn the key to the on position,see if any gas comes out,if not then your fuel pump is probably bad.
SOURCE: no cruise control no passing gear traction control light on .
Replace the cam and crank sensors.
SOURCE: MY 2005 DODGE RAM 5.7 HEMI STALL RPM GO UP DOWN, 1
Have you changed the fuel filter? If not' this may be your problem!
SOURCE: I need the wiring diagram
Hello kriswdorsey,
Below are pictures of the cam position sensor and the crank position sensor. I hope this helps.
Regards,
netvan
•
How to test Crankshaft Position CKP Sensor?
---------------
Crankshaft Position Sensor Operation?
----------------
Replace Camshaft position sensor and Crankshaft Position Sensor?
http://technoanswers.blogspot.in/2012/06/2005-dodge-durango-replace-camshaft.html
----------
GMC Crankshaft Position (CKP) Sensor
Replacing?
http://schematicsdiagram.blogspot.com/2011/12/gmc-crankshaft-position-ckp-sensor.html
------------
These details will help.
Thanks.
1,059 views
Usually answered in minutes!
×