How do I remove rear bumper to get access to Back up sensors?
SOURCE: How to Remove the Rear Bumper - BA Fairmont/Falcon
Firstly, you need to remove the rear splash shields from within the rear wheel arches and also the tail lights. Then remove the scrivets from the lover edge of the bar. Next remove the scuff plate at the boot opening and fold the carpet back. There are four nuts which hold the bar on, undo these and then lift the sides of the bar up and pull out. The bar has large clips on the side which hold it in place.
SOURCE: I want to fit a towbar to my ford focus hatch 2008
Pop the Hatchback open and remove the connectors
from the top of the bumper cover.
Optional Step: Using a Floor Jack, raise both sides
of the car in the back, supporting both sides with
jack stands, and remove the rear wheels.
Using Torx Bits, remove the inner rear wheel well
lining.
Get behind the rear wheel well and loosen the bolts
holding the bumper brackets on. They're pretty
difficult to find and remove. Be Patient. Do the
same to the other side.
Remove the rear bumper cover by pulling the cover
outward from the part nearest the wheel on both
sides. Once removed, take off the 2 black mounting
brackets from the bumper cover.
SOURCE: 1994 ford taurus rear speakers replacement
you have to remove the seat, remove the lower part first, it snaps in, then remove top part of seat, then you will see the pop in fasteners that hold the rear deck. if you have a problem go to this web site it will help with step by step instrucations. hope this is helpful. chttp://www.crutchfield.
SOURCE: How do you take bumper off a ford puma?
Front Bumper (434230)
Removal
1. Remove the radiator grille.
2. Remove the left-hand front wheel.
3. Detach the fender splash shield from the bumper cover and fender (both sides).
4. Remove the air cleaner intake pipe retaining clip.
5. Detach the air cleaner intake pipe from the air cleaner housing.
1 Rotate the pipe clockwise.
2 Detach the pipe.
6. Detach the bumper cover from the fender and support bracket (both sides).
7. Remove the left-hand side bumper retaining nut.
8. Remove the right-hand side bumper retaining nut.
9. Remove the bumper.
Installation
1. To install, reverse the removal procedure.
?€¢
Disconnect the electrical connectors.
515 views
Usually answered in minutes!
×