Question about 2005 Pontiac Bonneville

1 Answer

How hard to change rear plugs? - 2005 Pontiac Bonneville

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Depending on what motor it's not hard

Posted on Jul 02, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Changing the rear spark plugs in chevy uplander procedure and tools

Replace the 3 rear plugs from the bottom of the car. Jack it up and go up from the bottom of the engine. you will need a flex extension.
No need to remove anything but the plugs. Did this for my Montana and was not hard at all except getting the boots off.

Nov 28, 2011 | 2006 Chevrolet Uplander

1 Answer

How do I change the rear freeze plugs in my 1998 Olds silloette van with a 3.4 motor


Dec 04, 2010 | 1999 Land Rover Discovery

1 Answer

How hard is it to do a tune up on a 99 mercury

If it's a six cylinder, the air filter and fuel filters are accessible. The front spark plugs are not too hard. The rear plugs are difficult and you can expect to tear a knuckle or two trying to change them.

Jan 30, 2010 | 1999 Mercury Cougar

1 Answer

How do you change the spark plugs on a 2005 pontiac aztek how do you reach the rear

for these hard to reach plugs in the rear is a rachet extension with a hinged part that lets you remove these hard to reach plugs

Jan 04, 2010 | 2001 Pontiac Aztek

1 Answer


The only hard plug get out is the one one the passenger side rear. Anyone should be able to do this. Just be careful when removing the plug wires they tend to stick on the plug pretty well.

Oct 31, 2009 | 2005 Chevrolet Silverado

1 Answer

Best way to remove rear 3 spark plugs 2000 buick Lesabre

Most GM fwd v6s' have to be rolled forward to change the rear plugs. Its not as hard as it sounds though. Usually removing the air cleaner box and then taking the bolts out of the two top wish bone mounts allows you to roll the engine forward enough to change those plugs. You'll just need something to hold the engine forward while you change them. Like maybe a friend or a strap. I hope this helps you.

Aug 18, 2009 | Buick LeSabre Cars & Trucks

2 Answers

How do I change the spark plugs on a 1995 Chrysler Cirrus 2.5 l engine''

Well, you can easily get to the front three plugs. However, the rear three are under the intake manifold. You will have to remove it change the rear plugs. It's not too hard, just time consuming.

Jul 18, 2009 | 1995 Chrysler Cirrus

2 Answers

Changing spark plugs in a 2000 Poitiac van.

There are a few ways to doing this, and it takes time and a few band aids. You can remove the alternator to give you some room to access the rear spark plug with an extension and swivel spark plug socket. You can also get to the plugs from under neath if you have a ramp and long arm, an extension and swivel spark plug socket will help. You may have to use a 2x4 to wedge the engine to give you some room if you have larger arms. The other way is to tilt the engine forward by disconnecting the two top engine mounts. First replace the 3 front plugs and wire one at a time so you don't cross them. After you have changed the front plugs have a friend help you. Make sure the parking brakes are on and disconnect the two top engine mounts, release the parking brakes and let the transmission in park. Push the van forward slowly to tilt the engine forward far enough to give you room with out pushing it to far in to the radiator. Put the parking brakes on again to keep the van from rolling back and place a block of wood behind and in front of the rear wheels. Don't want to lose an arm. Replace the rear plugs with extensions and a swivel spark plug socket. Note, your going to have to replace the spark plug wire since the rear ones are really hard to remove and pulling on then will destroy them, not worth the headache trying to save them. Use platinum plugs so you can get 100.000 miles before you have to change them again so use anti-seize on the plugs so you can remove them again. Good luck and hope this helps, I personally go from under the van. 

Jul 06, 2009 | 2000 Pontiac Montana

1 Answer

Changing rear spark plugs on an 05 Bonnevile V6

No special tools, however the hard part will be getting the plug wires off without pulling the inner contact apart. Rotate the boots on the plugs before trying to remove the wires.

Jul 02, 2009 | 2005 Pontiac Bonneville

2 Answers

Changing plugs and power steering pump on an escape

I have a 2002 Escape V6 w/ 100,000 miles and I just changed the plugs. If you have a V6, you will have to remove the Upper Intake manifold. It's not too bad. You'll new a gasket set from Autozone or NAPA for about $10

Apr 04, 2009 | 2002 Ford Escape

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts


Level 3 Expert

79847 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides