Also rattling noise
SOURCE: A/C-Heat fan rattling then siezing, blowing the fuse. 2002 Maxima
It's time to replace the blower motor, bearing in blower motor have gone bad.
SOURCE: The fan on my 2002
For doing that you will require a tool.That tool is called j46406.This tool is used to loose or to tighten the nut.
----------
First read the procedure:---
Remove the fan hub nut from the water
pump shaft in a counterclockwise rotation. Using the j46406 tool , in order to secure
the water pump pulley, loosen the cooling fan hub nut from the water pump
shaft. Tilt the radiator and the condenser forward. Lift the fan and the shroud up and out towards the engine to
release the fan from the radiator to clear the radiator inlet. · Remove the
cooling fan and shroud · Remove the bolts
retaining the fan blade to the fan clutch. · Separate the fan
blade from the fan clutch. To order the tool to remove the nut,please click on the link below:--- http://www.etoolcart.com/fanclutchremoverandinstallerj-41240.aspx ------------------- Also click this link directly for more help:--- ------------- ----------------- If you dont have tool then other procedure is as follows:--- There is a clutch hub holding toll that you may need
but try this first, use a large hammer to sharply strike the handle of the
wrench toward the passenger side of the truck. Two or three sharp hits should
loosen the first thread of the hub nut so that you can spin it off the rest of
the way by hand. It does help to have the belt installed. Be carefull you don't
strike anything else. ---------------- This will help.Keep updated.Thanks/.Helpmech.
Unclip the
fan shroud from the radiator at the side panels.
· Remove the fan clutch from the fan shroud.
124 views
Usually answered in minutes!
×