Question about 1995 Nissan Altima

1 Answer

I have no power to ing switch ing fuse is good

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 750 Answers

Check for a broken wire or conector in harness

Posted on Jul 02, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2000 GMC Safari van keeps blowing ING A fuse. I crased the passenger side and the A/C system was crused. Dont know if that may help too.

As the ing fuse supplies power to the ignition switch and other units the if you are continually blowing the fuse after a crash then it is obvious that the wiring harness was damaged and the wire is shorting out either to earth or through other units to earth. You will have to check every inch of the harness and look for bruises in the wiring insulation or expanded plastic covering where the wire has been getting hot and burning.

Jun 14, 2014 | Cars & Trucks

1 Answer

No spark on a 1998 Chevy venture

Hi orvil brad hear I would check the ing. fuses you have at least one and maby two in the inside cab fuse block, and also one or two in the engine bay fuse panel, there is also a relay located in the eng. bay panel, also you may check the ing. wire that goes to the coil system, This wire will have no 12volts until the ing. switch is turned on then it will show 12volts. It has a habit of coming loose at the coil sometimes. Good luck

Dec 30, 2017 | 1998 Chevrolet Venture

1 Answer

My car(1996 Mercury Grand Marquis) will not start. Ipulled the starter, and had it checked, it was good. The Battery is good, the fuses are ok. Are there any relays between the Ing. Switch, and starter. Or...

There is a starter relay. Have someone familiar with auto electrical diagnosis test for ignition switch trigger signal at the relay, as well as power to the relay. Shouldn't be too hard to solve.

Jan 08, 2018 | 1996 Mercury Grand Marquis

2 Answers

How do you test a crank position sensor on a 2.4 lt. engine. wear is sensor located as well. engine will not start now . it was starting but now it will. i cleaned main power to fuse panal it was coroded...

remove the sensor then with a meter set to the lowest milliamp setting connect the meter to the two wires on the meter and move a spanner across the head of the sensor and see if the meter needle moves ,if it doesnt move renew the sensor

Dec 12, 2010 | 2000 Oldsmobile Alero

1 Answer

Has no spark. replace the control module and still no spark

first check for power at distribuitor terminal if pwr replace ing coil, if no power check ing switch, also a common problem is some one accidentally cause a spark or short one of the fuse links by the starter may be open check them all.

Sep 29, 2010 | 1988 Oldsmobile Delta 88

1 Answer

1996 chevy k1500 power to fuel pump fuse and

ck for a break ing the lin and ck for a good ground

Aug 12, 2009 | 1996 Chevrolet K1500

Not finding what you are looking for?
1995 Nissan Altima Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts


Level 3 Expert

80339 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides