Replace front light in mazda 3 - 2005 Mazda 3

Please check Page: 3-17

2023 Mazda 3 User Manual

https://www.autouserguide.com/mazda/mazda-3-sedan/2023-mazda-3-sedan-user-manual/

to replace the headlight, the bumper should be removed, in order to expose the bottom bolts of the headlight. be carefull, on the side of the fenders where the bumper clips in, it usually breaks if manhandled. this will cause the bumper to clip out in the fender sides.

hub assembly is the word that comes to mind they can make as much noise as a bad tire the easy way to check it out is with a really good flash light and the ability to get under the the vehicle look in on the back side of the wheel where the axle goes thru look for tinny lil pieces of metal that's the reason for the really good flash light the metal will reflect the light off that's the give away for me

Try removing and reinstalling the room 15A fuse in the fuse box under the hood, front most left hand corner of the fuse box when looking from the front of the car.

2011 Mazda 3 Car Stereo Wire Harness Color Codes
Car Radio Battery Constant 12v+ Wire: Brown
Car Radio Accessory Switched 12v+ Wire: Light Blue
Car Radio Ground Wire: Black
Car Radio Illumination Wire: Light Green
Car Stereo Antenna Trigger Wire: Black
Car Stereo Amp Trigger Wire: Light Blue
Car Stereo Amplifier Location: Under the Passenger Seat
Left Front Speaker Positive Wire (+): White/Yellow
Left Front Speaker Negative Wire (-): Blue/Green
Right Front Speaker Positive Wire (+): Red/Blue
Right Front Speaker Negative Wire (-): Red/White
Left Rear Speaker Positive Wire (+): White/Light Green
Left Rear Speaker Negative Wire (-): Pink/Brown
Right Rear Speaker Positive Wire (+): Light Blue/Brown
Right Rear Speaker Negative Wire (-): Light Green/Light Blue

2005 mazda 3 front wheel bering left side are they pressed in and tools needed 2 replace bering

there is alot of stripping to get at them remove the bumper and the rest is plain sailing

Replace the front brake pads and rotors.

for the most part you open the hood and turn the socket and the bulb come out if you have an autozone near you they will install it if you get the bulb from them and thats about any auto parts store

front end problems are not very uncommon becuse of the way we drive and where we drive, the front struts take quite a beating on the road thus giving us all the smooth comfortable painless noise less ride !!.

today the actual labor rate is soring and that is the reason for your big bills yet a reasonable price i would pay would be around $90 per side and the part will be around 200 for both front struts thus for a total of $400 for the front look into deals given by most auto speciality shops such as goodyear or pep boys but always ask for them to return your old parts to you this will be a good price around $400 - 450. for the front.

the noise you hear while you turn either to left or to the right while you are driving is bad front wheel bearings see if these are servicable bearings and if they are they can be cleaned and repacked with grease if they are sealed bearings then the bearings have to be replaced.