An expert who has achieved level 3 by getting 1000 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert whose answer got voted for 100 times.
Re: I need advice on installing a new fuel pump 1992...
Fuel tank has to be removed to remove fuel pump sender unit. make sure tank is near empty so its not as heavy to remove
some models have two round rings on top of tank, one is sender unit (for gauge) the other incorporates the fuel pump
others have one round ring which is both in one
remove the one near middle section of tank
be carefull not to bend float arm for sender unit if twin type (sender & fuel pump in one)
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Just did my fuel pump on the 2001 isuzu rodeo. Well here is what you need to do about the different wire colors. First disconnect your negative battery. Drop the fuel tank and replace pump. Remember to have a splice kit in hand. Ok now here is how you connect the different colored wires. Black goes with black. Gray goes with black and orange wire. Purple goes wit blue and yellow. And the last wires goes together. I hope this helps.
I have a 1992 Isuzu Rodio 3.1 injectors not working; but if i put gas in the throttle body it will start up and run. but while driving it down the street it will die and not re-start, until i put gas in the throttle body. the nod light does not work when it wont start. please can you help me with this problem, i have put a new fuel pump in it and two new injectors.
Underhood fuse block swap out relay #7 thats the ECM relay. Ground Circuits Using a DVOM, touch negative voltmeter lead to a good ground. Touch positive voltmeter lead to each ground terminal. With vehicle running, voltmeter should indicate less than one volt. If reading is greater than one volt, check for open, corrosion and loose connection on ground lead. See ECM GROUND LOCATION table for ECM ground location. Page 1 of 1 SYSTEM/COMPONENT TESTS - 2.6L EFI -1994 Isuzu Rodeo
I have a isuzu rodeo, i dropped tail gate removed carpet, i then located fuel pump from under truck, i took a jig saw and cut an opening through deck fuel pump is located on top of tank, it sounds messy but you can save a lot of money and time, after replacing pump silicone piece back in
Look on passenger side frame rail ahead of the rear wheel in a bracket with a fuel line on each end. Before starting replacement-- be sure to release pressure from fuel lines, by removing fuel pump fuse under hood and running engine to use gas from lines. I then remove fuel lines by moving clamps away from fitting so hose can be pulled loose from old filter while it is still in bracket. On top of mounting is a bolt that holds filter clamp in place . After removing clamp and filter from mounting bracket, loosen filter body clamp and slip oout old filter-- then in with the new filter. Then reverse your steps to install filter. After filter is back in place -- reinstall fuel pump fuse, turn on key for a few seconds for gas to refill lines, then start engine and check your installation to make sure you have no fuel leaks at line connections.