I have a '95 Bronco Eddie Bauer with the 5.8L in it. The Ac blows strong but only puts out air. I checked the r-134A and it reads full (reading 42psi). Any ideas what might be wrong?
I WHOULD CHECK MY LOW AND HIGH SIDE PRESSURES WITH A/C ON AND COMPRESSER INGAGED LOW SIDE SOULD BE AT 30-35 AND THE HIGH SIDE SHOULD BE AT 250 OR SO. IF YOUR HIGH SIDE IS HIGHER THEN THAT AND MORE AROUND 325-350 THAT MEANS YOU HAVE A INTERNAL PROBLEM. IF SO CHECK THE ORFAC LOCATED INSIDE THE SMALL LINE THAT GOES TO THE DRYER.DISCONNECT THE LINE FROM THE DRYER AND PULL THE OLD ORFAC OUT WITH A PAIR OF NEEDLE NOISE PLIERS IF ALL BLACK AND GUMED UP YOU MUST INSTALL NEW COMP.DRYER AND ORFAC MAKE SURE TO CLEAN OUT ALL LINES AVAPORATER CONDINSER.PULL VACUUM ON SYSTEM FULL WITH RECOMMENED OIL AND 134-A AND ENJOY THE COLD A/C.
The transfer case shifts to both high and low range but the front hubs don't lock in. Are there...
(More)
The transfer case shifts to both high and low range but the front hubs don't lock in. Are there common problems to this?
pushed clutch in and petal stayed on floor. vehicle is still in gear. clutch is realatively new and...
(More)
pushed clutch in and petal stayed on floor. vehicle is still in gear. clutch is realatively new and didn't have any problems untill i pushed it in to shift.
i have a 92 bronco and iam putting different doors on it that have power windows locks and...
(More)
i have a 92 bronco and iam putting different doors on it that have power windows locks and mirrors.can u help me with the wiring
I get axle lube on the passenger front wheel mag.It takes some timeafter cleaning the wheel 3-400...
(More)
I get axle lube on the passenger front wheel mag.It takes some timeafter cleaning the wheel 3-400 miles.