Question about 2001 Chrysler Voyager

3 Answers

2001 chrysler voyager speedometer needle stuck on bottom side of stop pin.

Posted by on

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 3 Answers

I have had this problem

put key in ignition (do not turn on) and press the trip button for about 30 seconds.

This should reset your speedometer

If one hits the trip button with the engine off it goes into a diagnostic mode and the speedometer pegs out. This basically lets it finish the diagnostics.

Dealer will charge you $800 for a 3 minute job.

I used this solution from Edmunds forums but cannot find the links anymore.

I have had two others reset theirs for the same problem.


Posted on Jul 10, 2009

  • Sheila Burgoyne
    Sheila Burgoyne Aug 27, 2012

    I used this method but didn't work..will try again TKS..

×

  • Level 1:

    An expert who has achieved level 1.

    Governor:

    An expert whose answer got voted for 20 times.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 14 Answers

Hold down the black plastic TRIP METER RESET switch for 10 sec and ti will go into diagnostic mode. I did this and its cool. Do it with the van turned off!

Posted on Sep 27, 2009

  • 3 more comments 
  • slw8651 Nov 15, 2010

    I was about to spend $200 to the dealer for a job that took me 2 min. thanks to you and this site. You guys are awesome!!!!!!!!!!!

  • rubyluna Dec 22, 2010

    I had this exact problem and I held down the Trip Meter Reset button and it corrected the problem. All is working OK now! Thanks, I'm sure you saved me piles of money if I had taken it into the dealer. Jim

  • cjbndee Jan 16, 2011

    JUST FIXED OURS BY THIS METHOD TOO, THANKS SO MUCH!!! IT WORKED

  • dxgonzo Aug 23, 2011

    2001 Voyager. You got another believer. Same issue and same results. Thanks!!!

  • gaparson52 Sep 20, 2011

    This solved my problem also. thanks!!!!!!!!!!!!!!!!!!!!

×

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 508 Answers

Get new speedometer head at junk yard or dealer!!!

Posted on Jul 01, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I fix speedometer that is stuck below zero?


dealer might be able to fix with the computer diagnostic tool. If there is a push button to reset odometer you can take a small wire and try and feed through the hole and raise needle above the pin. removing the instrument cluster cover is a pretty big task, if you cant find a place to insert a wire, only bypass I can suggest is drilling a tiny hole in the instrument cluster cover off to the side or top wherever the hole is least bothersome to you and then use a wire to raise above pin, after put a little clear silicone or a piece of tape over the hole to prevent dust building up inside the cluster

Oct 17, 2015 | 2001 Honda Accord 3.0 EX

1 Answer

2001 honda accord speedometer needle stuck below pin


You need to get that needle over the pin. Remove the cluster face and manually do that.

Dec 20, 2013 | Honda Cars & Trucks

1 Answer

Speedometer needle is behind pin, in a 2001 chrysler town and country. instead of buying part what else can i try?


This is an ez repair. Remove the trim around the dash of the speedometer. Unscrew and remove the plastic cover over the speedometer itself. Move the needle to it's correct position. Should take less than half an hour.

Jun 08, 2011 | 2001 Chrysler Town & Country

2 Answers

The speedometer neddle on my voyager 2001 has gone all around and now the needle is stuck under the needle and can´t get upp! (It happend when the battery went down)


This worked for me. Put the key in the ignition, but do not turn; press the trip reset button and hold until you see "SOF" you will then see the SOF and a number and an error code. Diagnostics will run and the needles on all the gauges will move during the procedure. The speedometer needle should be reset and working when done.

Jan 17, 2010 | 2001 Chrysler Voyager

1 Answer

I have just replaced the heater core in my 98 dodge dakota and my speedometer is stuck on 120 what shall i do


when you had the dash on its way out it got tilted and the free moving hand in the speedometer floated around the ring,
now you have to remove the cluster and hold it up side down to get the needle to float back to the other side of the stop pin.
or, drill a small hole at the base of the speedometer and take a piece of wire to move the needle,
good luck

Nov 22, 2009 | 1998 Dodge Dakota

2 Answers

2001 chrysler town and country. need to reset speedometer. the speedometer is stuck on the back side of the resting pin. we have reset it before but forgot how to do it now.


Hold down the black plastic TRIP METER RESET switch for 10 sec and ti will go into diagnostic mode. I did this and its cool. Do it with the van turned off!

Sep 13, 2009 | 2001 Chrysler Town & Country

1 Answer

2001 Town & Country batterys bad/speedometer got stuck behind 0


a scanner that gets into the instrument cluster computer can reset the needles. or take the dash apart and manually turn dash cluster upsidedown, then the needles will move so rotate untill the needles are reset.

Aug 26, 2009 | 2001 Chrysler Town & Country

1 Answer

1999 Subaru Forester speedometer not working


About the only way is to diassemble it, but it sounds like it's not wrth doing. Your speedometer is having some real malfunction issues anyway. Might as well get a new one (or used). If you did get the needle to the right place, it's just going to end up in the wrong one again.

May 15, 2009 | 1998 Subaru Forester

1 Answer

My speedometer needle is stuck all the way around to the stop. What is the cause and how much to fix?


pull the cluster and you can tilt it to work it around or take it to the dealer and the can do it running a gauge test

Jul 17, 2008 | 2002 Chrysler Voyager

1 Answer

How to remove a radiator


Change radiator in 2001 Chrysler Voyager

Jul 08, 2008 | 2001 Chrysler Voyager

Not finding what you are looking for?
2001 Chrysler Voyager Logo

1,199 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...