Found a vac line that plugs in under carb,Little metal sleeve that a vac line goes to
SOURCE: spark plug boot
hi im wes
the sleeve is a heat shield it keeps the manifold from baking the boot if you leave it off it will still work for a while it will however fail much earlier than if you put it back on hope this helps
thanks wes ps please rate me
SOURCE: plug boot has a metal sleeve any trick to getting boot off it is very hard to pull off
i would invest in spark plug puller the pliers is about 10 or 15 dollars save money in the future.pry them wires right off with them
SOURCE: looking for a diagram of how all vacum lines hook
See if this is what you are looking for. I hope that this helped and best wishes.
SOURCE: looking for a vacum line diagram so i can print it 1996 gmc jimmy
GMC S10/S15/Sonoma Pick-Ups 1982-1993 Repair Manual
VACUUM DIAGRAMS (See Figures 1 through 85)
Below
is a listing of vacuum diagrams for most of the engine and emissions
package combinations covered by this manual. Because vacuum circuits
will vary based on various engine and vehicle options, always refer
first to the vehicle emission control information label, if present.
Should the label be missing, or should vehicle be equipped with a
different engine from the car's original equipment, refer to the
diagrams below for the same or similar configuration.
Check the link autozone.com (free register), select the year ('91 sample), Brand, Model, Sub-Model, Engine Size and make the next root...
1991 GMC TRUCK S15 4WD 4.3L TBI 6CYL REPAIR GUIDE >> EMISSION CONTROLS >> VACUUM DIAGRAMS
I really hope helps with this (remember rated this help). Good luck.
SOURCE: puting vac hoses back on and carberater on a 1984
The engine and emission control system covered by this information
operate on a combination of vacuum and electrical signals; they are
extremely prone to malfunctions due to improper vacuum connections. If a
component does not receive vacuum at the correct time, it cannot
function when needed. When working under the hood, pay close attention
to the routing and placement of every hose.
Fig. 1: The vacuum hoses are usually numbered for easy
identification
Fig. 2: Vacuum hose routing-1984-85 carbureted Prelude
Fig. 47: Emission component schematic-1984-85 carbureted
Prelude
Hope this helped; TY for using Fixya (remember comment and rated this).
129 views
Usually answered in minutes!
×