Question about Ford Tempo

1 Answer

I need help replacing a 1993 Ford Tempo Window motor. I already have the panels removed and I need to remove the motor to put in a new one.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 424 Answers

You will have to drill hose to gain access to the three 8mm bolts holding the motors tor the regulators. I use a 9/16 hole saw where the three dimples are on the door. The dimples should line up with where the bolts are,but sometimes they are off a little. I hope this helps.

Posted on Jul 03, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need water pump impeller cap 1993 tempo


Impellor cap near fire wall ,when you start the vehicle does the window get all foggy, because if it does you need a heater core because that near a fire wall,

Aug 12, 2012 | 1993 Ford Tempo

1 Answer

93 ford tempo need rear bumber


your best bet is a junk yard ,to replace jack rear of car chock front wheels for safety ,i believe is about eight bolts holding it against a flat plate you cannot miss it four on each side put w-40 if needed to remove

Mar 07, 2011 | 1993 Ford Tempo

1 Answer

Power windows will not work on '92 tempo


This is a common problem with Fords of this era. Most people mistakenly replace the motor which is expensive, but there are repair kits available that replace the gear unit in the motor mechanism.

One way to check to see if this is the problem is to open the door, sandwich the window glass with both hands and shove down. If it goes down then you need a kit. Or, if you press the window button and the motor makes noise but nothing happens, you need a kit.

Basically there is a large plastic gear that has 3 synthetic bumpers that hold a metal gear. These bumpers age and begin to deteriorate and eventually disintegrate. Sometimes the plastic gear strips out.

Search these part numbers for a picture or check out Napa or Autozone's website for an image.

Part # BK 6551128

Part #
RAY 4922277

These normally run 20 bucks or so.

If you don't have a repair manual and you plan on working on your own car, get one. Haynes is ok but the best is an actual Ford Shop manual is priceless. Ebay is the best place to get them. My cougar manual cost 25 dollars and I wouldn't sell it for 100. You need the manual so you can get the door panel off with out breaking it too much. The plastic is old enough to vote and you can't glue it back together. I also recommend getting an interior panel pry tool for the same reason. Preferably a metal one as you can use it for other purposes as well.

Back to the window...

Replacing the gear goes as follows:

Raise window and remove door panel.

Remove window motor.

Remove the 4 screws and pop off the rubber seal. Grease the new plastic gear and reassemble and reinstall everything.

If I remember correctly one of the screws on the motor is a torx.

Jun 03, 2010 | 1992 Ford Tempo

1 Answer

How do i replace the fuel tank on my 93 tempo?


remove gas tank straps and make sure to unplug the fuel pump harness and remove filler tube from tank it is usually screwed down where you put gas in to fill it up

Jan 10, 2010 | 1993 Ford Tempo

1 Answer

DESCRIBE HOW TO REMOVE A STARTER FROM A 93 FORD TEMPO


First disconnect the battery. After that, find the starter (should be bottom right). Remove the wires from the starter making sure you remember where they go. Remove the two bolts that hold it in place (one on top, one on bottom). Reverse all of this to put the new one in.

Oct 24, 2009 | 1993 Ford Tempo

1 Answer

Need to replace the power window motor on a chevy


To replace the power window motor:

1. Remove inside door panel, and locate the motor.

2 Unplug the motor, drill out the rivets that hold it in, then you can remove it.

3. the new motor may come with fasteners to install it, otherwise use 1/4 - 20 nuts and bolts to attach the new motor.

Sep 13, 2009 | 1993 Chevrolet Astro

1 Answer

I have a 1993 Ford Tempo and am having problems removing the motor from the door. I already have the door panel removed and the power disconnected from the motor.


remove the door panel and check to make sure the linkage to the lock assembly is still attached. I can't give an estimate because I don't know what is wrong at this point

are the locks manual or electric?i have seen most electric locks freeze up because of rust/.corrosion.the rubber accordian seal fails and moisture does it's job.there is no lubrication on the mechanism.it's basically a push pull magnet tube with a spiral grooved actuator rod.this is to assure no accidental vibration/jar induced movement.also means very difficult to budge when corroded.i have gotten a few to move by grabbing lock post with pliers and pulling hard.good luck!



Rear Door Window Regulator and Motor
Removal and Installation
Remove the rear door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
Remove the door mounted speaker.
Remove the watershield.
NOTE:The glass must be lowered for this step.

NOTE:Some vehicles may use rivets to attach the glass to the regulator.

Remove the bolt that attaches the glass to the regulator.
Raise and support the rear door window glass to the full up position.

NOTE:Do not detach the door handle from the latch cable during this step.

Remove the rear inside door handle.
Remove the screw.
Disengage the inside door handle from the door.
If equipped, disconnect the power door lock rod from the back of the inside door handle.

Gain access to the power window motor electrical connector located in the front of the door.
Fig. 90: Identifying Power Window Motor Electrical Connector
Courtesy of FORD MOTOR CO.
Disconnect the power window motor electrical connector.
Press down on the connector tab.
Pull the connector upward and remove through the speaker opening in the door.
Disconnect the rear door window regulator and motor assembly from the door.
Remove the nuts.
Remove the screws.
Fig. 92: Disconnecting Rear Door Window Regulator And Motor Assembly From Door
Courtesy of FORD MOTOR CO.
266999_door_2.jpg
Remove the window regulator and motor assembly from the door.
Fig. 93: Removing Window Regulator And Motor Assembly From Door
Courtesy of FORD MOTOR CO.
266999_door_3.jpg

To install, reverse the removal procedure.

Jul 01, 2009 | Ford Tempo Cars & Trucks

2 Answers

Need to replace broke window on 93 ford tempo.Pass. side


Door Glass, Front Removal
  1. Remove door trim panel and watershield. Refer to Section 01-05. ani_caut.gif CAUTION: Prior to removing center pins from the rivet, it is recommended that a suitable block support be inserted between door outer panel and glass bracket to stabilize glass during rivet removal. Remove center pin from each rivet with a drift punch. Using a 1/4-inch diameter drill, drill out remaining rivets as damage to plastic glass retainer and spacer could result.
  1. Remove two rivets attaching glass to run and bracket assembly.
  1. Remove glass.
  1. Remove drillings and pins from bottom of door.
Installation
  1. Snap plastic retainer and spacer into two glass retainer holes. Make certain that metal washer in the retainer assembly is on outboard side of glass.
  1. Insert glass into door.
  1. Position glass to glass bracket. Install two rivets to secure glass to glass bracket. NOTE: Two 1/4-inch-20 x 1-inch bolts and two 1/4-inch-20 nut and washer assemblies may be used as alternates for glass retention. However, torque must not exceed 4-7 Nm (36-61 lb-in). Equivalent metric retainers (6mm) may be used.
  1. Install door trim panel and watershield. Refer to Section 01-05.


2-Door Vehicles


n5878h.gif



4-Door Vehicles


n5879g.gif

May 29, 2009 | 1993 Ford Tempo

1 Answer

How do you remove and replace a drivers side door window on a 1993 Ford Tempo


The first step is to remove the door panel. The door panel is held on to the sheet metal door frame by plastic push pins that fit inside the door panel (where you can't see them). Use either a flat head screwdriver, or probably a pocket knife would work best, and slowly work your way around the door panel prying the panel and plastic push pins away from the sheet metal. There will be most likely a couple of regular screws in the middle of door but will be much easier to notice where when you have the those pins pushed out. Once you have the panel off your window motor sits inside your door frame and is bolted on (3 bolts if I remember correctly) and attaches right on your window lift assembly. Your window is also fastened to the assembly by two plastic clips that push in on the very bottom of the window. When removing those clips be careful not to apply too much pressure as the curve of the glass makes it very easy to shatter. It would help if you could get someone with small hands to do it. Once the clips are removed you can remove the entire window and replace. PS If you break a few of the plastic push pins don't fret because Autozone sell packs of them to replace. Hope this helps, let me know how it goes and if you need some more help. Good luck!

May 05, 2009 | 1993 Ford Tempo

1 Answer

Windows


remove the window switch, pour rubbing alcohol over it while scrubbing it with an old toothbrush, and let it dry for 5 or 10 minutes- it should be fine...also check your power window fuse under the dashboard in the fusebox.

Jan 06, 2009 | 1991 Ford Tempo 4 Door

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...