Question about 2004 Chrysler Crossfire

4 Answers

Chrysler Crossfire will not start

I've expericenced this a handful of times, i go to start my car and nothing, the lights and radio come on but no motor, not even a clicking or any sound from motor. It has even stoped working while i was actually driving. Most times it will start working again after a few hours. Its currently at the dealership and as of now they say they can't find anything wrong with it.

Posted by on

4 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

It turns out that the fuel pump relay is the problem and that this (per chrysler) is a common problem with the crossfire.

Posted on Jul 01, 2009

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

I am having the same problem, i found the the electrical connectors to the relays in the computer compartment are junk. i can put pressure on them and the car will start and run fine. if i move them at all the car will backfire or shut off. it will restart sometimes but i ussually have to move around the connections. i am currently trying to solve this problem. i wish i could cut and solder directly to the relays but they go to a circuit board which is complicated when messing with.

Posted on Sep 09, 2009

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 3 Answers

Could also be an intermittant sensor failure from the crankshaft sensor

Posted on Jul 01, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

My 2004 Crossfire just stopped running one day. A shop was near by and did a dianosis but nothing came up. When the wrecker arrived, it started. I later learned that it was the crankshaft sensor...it is located to the rear of the engine and you can replace it yourself. The dealer charged me over 400 dollars to buy and replace. I have since learned that on some some cars the camshaft sensor located on the front of the Crossfire will stop working also. In some cars, if one goes out, both have to be replaced.

Posted on Sep 27, 2012

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need code number to unlock radio for Chrysler crossfire


When you disconnect your battery and then reconnect it again, it disables the radio. This is an anti-theft protection for your car radio.
The enable your radio the activation code is in your vehicle owner's manual. If you do not have this code you need to go to your Chrysler service centre and get them to enter this code for you.

Nov 28, 2012 | 2004 Chrysler Crossfire

1 Answer

I want fog lights to turn on when i start my 2005 crossfire


Install the factory daytime running light kit, it is available from any Dodge/Chrysler dealer parts dept. Comes with easy to follow instructions.

Apr 22, 2012 | 2005 Chrysler Crossfire

1 Answer

2004 crossfire...turn key..no start..no sound..all lights work..try maybe 3 times ..it starts..intermittant problem


The lights are on their own personal circuit from the starter. Every time you turn the key on the connections are getting warmer each time. You state after the 3rd time it will start. You will need to check all connections to make sure they are very clean and tight. A loose or corroded connection will cause a problem such as yours

May 26, 2010 | 2004 Chrysler Crossfire

2 Answers

2004 Chrysler Crossfire won't start. Drove in


This is not the problem I have a chrysler crossfire and experienced the same problem there is some good news if it frequently stops working for no reason the problem is most likely the RCM module has a shortage in it I fixed my crossfire and 3 others buy repairing the RCM its easy and simple any question you can email me I can give you a easy walk through to fix the problem and avoid paying hundred at the dealership it shouldn't take no more than 15 minutes to fix DIY!!

Apr 05, 2010 | 2004 Chrysler Crossfire

2 Answers

05 Chrysler Crossfire Convertible top


Try using urethane sealant to redo the seal between the top and the glass.
I have a VW convertible that had the same problem. The sealant comes in a tube that you use in a caulk gun. Made by 3M and I purchased it from Advance Auto. About 18 bucks.

Jun 02, 2009 | 2007 Chrysler Crossfire Convertible

1 Answer

Drivers Heated Seat Only Part Working on Chrysler Crossfire


Seems like a huge coincidence it stopped working at the same time it was visiting the dealership. I suggest you take it back and complain that they broke your seat.

You have nothing to lose and will probably get the fault diagnosed free and maybe more...

Apr 11, 2017 | 2004 Chrysler Crossfire

2 Answers

2004 crossfire starting problem


I had this problem and it need to have the crank shaft position sensor replace and it worked immediately I found this out the hard way after the car died several times and took time to start again

Nov 18, 2008 | 2004 Chrysler Crossfire

2 Answers

Converting built in infinity radio tuner to get european stations


Hi Barak, I have not seen an easy adjustment on any car stereo for converting the frequencies. The Crossfire stereo is manufactured by Becker. Try Becker of North America in Upper Saddle River NJ.

Nov 13, 2008 | 2006 Chrysler Crossfire

Not finding what you are looking for?
2004 Chrysler Crossfire Logo

1,744 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...