Question about 1996 Dodge Intrepid
Sounds like a stuck button that prevents the other ones from working. If it's actual buttons then a tiny shot of Wd might free it up. You may have to replace whole panel.
Posted on Jul 01, 2009
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
I finally replaced the Backlights, using a guide from a person at www.answerbag.com
(i've got an 04 limited. i just soldered in new bulbs for the lighting controls panel (5 #272-1092) and the digital HVAC panel (1 #272-1092 and 5 #272-1154). steering wheel control bulbs are next. )
Just buying a cheap Used one may be the best, if you are not good with dis-assembly and soldering small electric bulbs
Depending on the style you can get a Used One from an online junkyard for 25-50 USD
Check LKQonline out..
The most difficult part is getting the Climate Control Module out of the dash, to make the soldering new bulbs repair. The wood-grain Bezel needs to come off, BE CAREFULL, its long and flexible and can crack easy if the wrong pressure is applied or its cold outside or cold in the car cab. Its held in the dash with GM friction clips ( pain in the %$#) and 2 Phillpis screws behing Glove Box door. I worked the pull- pressure from the A/C vent on Right, left-ward to the center, and from Steering Column right-ward toward the center. Once the Bezel is removed, the Climate Control Module is seen, with 4 push-tabs on each corner. BE CAREFULL pushing in the tabs....I broke off one as in pushed too hard. Pry out Right side while pushing 2 right-side tabs gently together. Repeat for the Left Side, while pushing 2 left-side tabs together gently. The Climate Control Module should pop out. Use a 3/8inch Nut Driver to remove the headless screws that hold the Climate Control Module PushButton plate to the box. This will expose the Printed Circuit Board for solder replacement of the Bulbs.
Posted on Dec 01, 2008
Tips for a great answer:
Jan 22, 2016 | Cars & Trucks
Mar 06, 2014 | 2000 Mercury Grand Marquis
Feb 08, 2013 | 2011 GMC Acadia
Jun 28, 2011 | 1999 GMC Yukon
Apr 21, 2011 | 1992 Chrysler New Yorker
Sep 10, 2010 | 2000 Chevrolet Monte Carlo
Oct 17, 2009 | 1997 BMW 328
Jul 31, 2009 | Chevrolet V30 Cars & Trucks
Sep 01, 2008 | 1995 Buick LeSabre
44 people viewed this question
Usually answered in minutes!