Question about 1999 Dodge Ram 2500 4WD

1 Answer

Wipwers just stop. checked fuse and relay all ok?

Fix

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 176 Answers

Wiper linkage are jammed

Posted on Jul 01, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Starter suddenly stopped engaging. could it be a relay switch


check fuses, it could be the relay, if it checks out ok, then the starter solonoid could be @ fault, FUSES FIRST, RELAY 2nd, STARTER/SOLONOID LAST, make sure battery & terminals ok, cleaned, tight, etc., battery must be fully charged ! you should have a relay box under hood.

Mar 11, 2013 | 1995 Nissan Pickup

1 Answer

Flasher relay in a 98 mercury grand marquis?


The fuse block the relay is located in is behind the knee bolster, the trim panel under the steering column, left of the steering column underneath the dash. Common source of problems if that does not fix it is the Light Control Module ( LCM), turn signal switch unit, headlight switch.

Mar 08, 2013 | Mercury Grand Marquis Cars & Trucks

1 Answer

My ac stop working,I checked compressor ,it's ok ,no power to compressor


Some possible causes are the system is low on freon, a faulty compressor clutch, faulty low pressure switch, relay, fuse, or control switch.
Do you have power at the fuse and the relay ?

Jul 15, 2012 | 2001 Chrysler Sebring

1 Answer

I blew my horn and it stuck.. keep mashing it and it stopped.Now it won't work at all.I have not checked my fuse yet,do you think it could have blown the fuse? I don't know where the relay box is either.


Fuse is probably OK, but switch is coming apart. There is no way to short it in the column, as it is strictly a ground connection. It's worth your time to check both the fuse and the relay though, because fixing the switch is a real pain. Both the relay and the fuse are in the box under the hood. I have pasted your diagram below. I can send you the instructions for getting into the steering column, if you want to get into it. Lemme know.


jturcotte_320.gif

Nov 27, 2010 | 2003 Chevrolet Malibu

1 Answer

Where is the ac/heater fan fuse for 97 nissan pathfinder


the cooling fans on autos require a motor, a power wire , a fuse ..........and




relays. ( look under your hood for a black box with some 1 inch by 1 inch black square relays ) under the cover it will tell you what relay is for the fan.
u can take another relay out of the same relay box and test the fan circuit ( as long as the pins look the same and the relay looks the same
) and plug it in and see if that fixes the problem........if it does, go buy a new relay ( remember to put them back where you got them from)

its either a blown fuse, a bad relay, or the motor finally gave up. try the fuses and relays first

Jul 31, 2010 | 1997 Nissan Pathfinder

1 Answer

Turn signals stopped working. Fuses are all ok,


sounds like the flasher can might have stopped working, you will need to get it replaced, it regulates the indicaters to blink, when it goes the circuit is gone, time for replacing id say. check the relays in the main fuse box under the bonnet first, try swapping the relay with another one like the horn relay just to test that first.

Jun 21, 2010 | 1999 Cadillac DeVille

1 Answer

Heater blower stopped working??


Check fuses, there may be more than one fuse that controls the blower motor. If fuse is OK, then check relays (somewhere in a box). If relays and fuses are OK, then check (some dashboard dissassembly required) if voltage is getting to the blower motor. If there is voltage present, then suspect burnde blower motor, or if motor works only at full speed, then suspect a burned resistor in the blower motor assembly.

Sep 25, 2009 | 1994 Chrysler LeBaron

1 Answer

Wipwers just stop. checked fuse and relay all ok


I suspect you have a bad wiper switch. there is no seperate relay.

Jul 01, 2009 | 1999 Dodge Ram 2500 4WD

1 Answer

Windshield wipers


From your owners manual:

Fuse#11 30A , Wiper Run/Park
Relay, Wiper Hi/LO Relay, Windshield Wiper
Motor, Rear Washer Pump Relay

U will also need to check the relays if the fuse is ok, the relay, it is the underhood fuse box
Relay #202 — Front Wiper Run/Park Relay

Dec 18, 2008 | 2001 Lincoln Navigator

2 Answers

Power windows


First thing you do is check the fuse, if its ok you check the relay and if that does not fix the problem the switches may be dirty and needs a little cleaning. You could also test the wires across the motor while pressing the switch to see if current reaches the motors and work your way back from there.

Jul 17, 2008 | 1996 BMW 318

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...