2002 Ford ZX2 Logo

Related Topics:

A
Anonymous Posted on Aug 15, 2014

My ford zx2 fuel line keeps poping off

My fuel line keeps popping of my car

1 Answer

Dave

Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Hot-Shot:

An expert who has answered 20 questions.

  • Contributor 36 Answers
  • Posted on Aug 15, 2014
Dave
Contributor
Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Hot-Shot:

An expert who has answered 20 questions.

Joined: May 19, 2013
Answers
36
Questions
0
Helped
10393
Points
88

Take it to the dealer they should install a safty lock on the fuel line to prevent this good chance if they are a good dealed they will do it as a recall or coustmer satifaction program.

4 Related Answers

Anonymous

  • 114 Answers
  • Posted on Mar 25, 2009

SOURCE: fuel injectors fuse is poping 30 amp, but before

the smoking inside your car are the wires burning, only use the specified fuse rating.Your going to have to spend some time tracing wires to see what is shorted.Get yourself a schematic and start with testing the resistance of your injectors to see that they are not shorted out and trace your way back to the fuse panel.
A quick way to check the injectors is to take the fuse out and put a test light from one fuse contact to the other,if there is a short then the light will be lit.Unplug an injector and see if the light goes out if yes then that is the bad one,check them one at a time,you can also use this method to unplug connections in the harness ,if the light goes out then the fault is between there and the injectors.Also check the manual to see what else is controlled by that fuse, might not be the injectors.
Before you do any of this,inspect the fuse panel and all wire to see that you have'nt melted any wires together and that maybe the wires were shorted out there to start with.Don't keep putting fuses in or you risk catching your car on fire
Good luck

Ad

Anonymous

  • 305 Answers
  • Posted on Aug 02, 2009

SOURCE: When the car is filled up (Ford Escort ZX2) the

the fuel sender unit is a float system, sounds like the float has a hole in it, and has fuel inside, therefore the float will not rise to the top when the tank is full...
disconnect battery..locate sender unit on top of fuel tank,,( usually located under rear seat )....remove the float and clean thoroughly....then repair hole

ZX2Fast

Brad Kirby

  • 547 Answers
  • Posted on Mar 05, 2010

SOURCE: instructions for replacing fuel pump in a 2001 ford Escort ZX2

Remove the rear seat, remove the 4 screws holding the metal cover, and you'll see the top of the fuel tank. The pump module is held in place by a locking ring that can be removed by use of a brass punch and hammer. If the ring is rusted, it'll get damaged during removal and will need replaced. You can get a new ring from Ford. Once the ring is removed, you can pull the pump module out. Remove the small screws from the top of the module and you can pull the top off of the basket to gain access to the fuel pump. Replace the pump and get new fuel pump strainers.

woodchuck789

Charles T Nevin

  • 4070 Answers
  • Posted on Sep 09, 2010

SOURCE: my belt keeps popping of

One of your pulleys is probably wobbling letting it come off. With the belt off check each pulley for play and ease of spin.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers
0helpful
1answer

1991 ford f-150 302ci 4x4 idles rough, fuel is rich, poping through intake and wont wined up

Check your timing anytime it pops back the timing is usually off.
0helpful
1answer

98 ford escort zx2 dies when it drops below 1000 rpms

I doubt the two problems are related.
The computer uses an idle speed control valve to regulate idle speed. The valve controls the amount of air entering the intake.
You should have a check engine light on and also a stored trouble code for the valve. It could also be a problem with the throttle plate in the throttle body.
0helpful
1answer

Replacing plugs on 2003 Escort ZX2

Instructions1 Pop the hood and locate the fuel rail on the intake manifold. Connect the fuel pressure gauge to the Schrader valve at the end. Push the manual relief valve on the gauge to relieve the fuel pressure in the system.
2 Place a drain pan underneath the center of the engine, on the driver's side by the firewall. Locate the fuel filter, which is on the firewall on the driver's side, toward the backside of the engine.
3 Disconnect the fuel lines running to and from the fuel filter using the pliers and then unbolt the filter from its mounting bracket using the 3/8-inch ratchet and socket. Remove the old fuel filter and discard it.
4 Set the replacement fuel filter in place. Make sure the arrow on the filter is pointing toward the engine and away from the gas tank. Secure it in the fuel filter bracket using the ratchet and then reinstall the fuel lines using the pliers.
5 Start the engine and make sure everything is running correctly.
Thanks
0helpful
2answers
0helpful
1answer

My belt keeps popping of my car & causes my car to run hot instantly. this is the 3rd time within 1mth -11/2. make and model is FORD ESCORT ZX2-1999

One of your pulleys is probably wobbling letting it come off. With the belt off check each pulley for play and ease of spin.
0helpful
1answer

Belt routing for a 2000 2.0 ford zx2

Listed by Asker under a 2002 Ford ZX2 for a 2000 Ford ZX2:

Click on the following direct, free Link. It has several Belt Diagrams including for your 2000 Ford ZX2 2.0L DOHC In-Line 4-Cylinder. It has several other diagrams that may be also useful for you.

Let me know if this helped, or if you have additional information questions. Feel Free to contact me at FixYa.com!
http://www.2carpros.com/car_repair_information/year/2000/make/ford/model/zx2/2000_ford_zx2_drive_belt_routing_diagram.htm
0helpful
1answer

I have a 1999 ZX2 ford escort that starts, but dies in seconds

It is was a gas filter problem blocking gas flowing from the pump. What happening was that when it was trying to **** the last drop of gas into the engine it really disturbed dirts inside the fuel filter and made it clogged at fine mesh. And also make sure give sometime for gas delivered into the fuel line it since it was empty when you change the fuel filter. It means you have to keep starting for a while so gas can go up to the fuel distributor then injectors.
1helpful
1answer

My Fuel Fuse Keeps poping

I'd try a 20 amp maybee even a 25
0helpful
1answer

My fuel pump fuse keeps popping and we just changed the fuel pumpand it still pops it what could that be {98 dodge neon)

Check your power wire to the pump. It must have a bare spot somewhere, and is grounding out. Probably on top of the gas tank.
Not finding what you are looking for?

76 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...