Question about 2000 Mitsubishi Eclipse

1 Answer

It acts like it is loading up when you give it the gas, but not all the time. The check engine light is on and the test for it i was told that it had to do with the catalytic converter.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Try unpluging then repluging in your TPS (throttle position sensor) its located on the end of your intake. it reads the position of your throttle and works with your ECM, and the O2 sensors to control your air/fuel mixture. if its running rich and not burning off all the gas it would also throw off your O2 sensor that is attached to the front of your catalytic converter. sometimes these sensors get gummed up and they send inacurate information to the ECM.

Posted on Jul 01, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car acted like it wasn't getting any gas and then ran fine. did this a couple times. chec engine light is now on


the CEL means, SCAN me now.
the car needs service, 2 things told you that
the stalling, bogging or misfiring,
and that CEL glowing there steady.
all cars, 1989 to now., an
CEL = check engine light, aka. SES, or MIL.

Jun 03, 2014 | 2003 Suzuki Aerio

1 Answer

I have a 94 Chevy silverado 4x4. Ill start the truck ot turns over and then shortly dies. If I restart and give it a little gas it stays on. But lately when I come up to a stop light it sputters and acts...


you need to do a battery load test to see if battery is good check to see if alternator is charging if that all checks out good i would look for a loose or corrected ground cable from battery to engine or frame to engine sounds like a ground issue to me or loose connection

Nov 10, 2017 | Cars & Trucks

1 Answer

97 gmc acted like had bad gas but now also at idle with brake on engine will surge and engine sounds like it s missing


Hi Allen, The brake booster is connected to the intake manifold and that is where the low pressure is generated. If the diaphragm or one way valve, or connection pipe is leaking it will give the same effect as a leakage on the intake manifold. The symptoms you report are of a leakage on the intake manifold. To prove one way or another, disconnect the vacuum pipe for the booster and block the connection into the intake manifold. Be careful when testing as you will need to use excessive force on the brake pedal to stop. If the symptoms disappear fit a new booster, if not, pour water along the manifold and observe any bubbles where there may be a leakage. Let me know how you get on. Regards John

Aug 10, 2012 | GMC Sierra Cars & Trucks

1 Answer

1998 Mystique wont start, ignition turns over but acts like it's not getting gas.


Does the check engine light go OUT while cranking? If not , if it stays ON, you've got a bad crankshaft position sensor. These can fail with intermittent no starts. So just when you have it towed it, it'll start working again. Check engine light is supposed to go OUT if it's getting good signal from the sensor.

Jan 01, 2018 | 1998 Mercury Mystique

1 Answer

Turns over but acts like it's getting no gas


Possibly check valve in fuel pump is allowing the fuel back into the gas tank

Turn ignition key to ON so the dashboard lights are lit for 5 or 10 seconds,
then CRANK the engine.

This will allow the fuel time to get back to the engine. May take several tries.

Known problem, friend was recently told new pump would have to be installed $500+, decided a few extra seconds to start car once in a while was better option.

May 15, 2012 | 2005 Nissan Altima

1 Answer

1998 toyota camery le engine light on misses when i give it gas


The engine light is on because the car is telling you that something is wrong. It is putting out codes and you need a diagnostic tool to check for the solution.

Apr 17, 2012 | 1998 Toyota Camry

2 Answers

My check engine light came on. I had it checked with a scanner. I was told the code came up that it was the gas cap is not sealing and to buy a new gas cap. I did. The check engine light came back on two...


Best not to ignore the check engine light because it also can indicate a serious running problem just as it is indicating a pollution problem now. I don't trust folks that have 'snap' answers for a given problem without any kind of testing (the fuel cap). This problem can be caused by split vent hoses or fuel filler hose, sensors that leak or read incorrectly--the list goes on. Smoke generator tests can help track this down but require intelligent analysis to replace or repair the correct component. Finding someone like this to take the time to be at least fairly sure of a cure before loading the car up with unnecessary parts is a rare find. Good luck!

Jul 17, 2010 | 2000 Chevrolet Cavalier

1 Answer

My automatic car acts like it is going to stall


Definitely sounds like a fuel problem. I'd change fuel filter and check fuel pump. If pump is running it could still be partially clogged. Try a fuel rail pressure test with a knowledgeable mechanic.

Jan 25, 2010 | 2005 Toyota Corolla

3 Answers

Wanting to stall at all speeds


It sounds like a electrical problem to me. Like the ignition control module. It can be tested at your local auto parts stores.

Sep 17, 2008 | 2002 GMC Envoy

1 Answer

Car starts to buck and then shuts off. We were told it was the main computer, had it replaced, to no avail.Took it back and were told there was water in the gas tank, they drained it.... Continued with the...


Is this a V6 VQ35 or 4 cylinder QR25?? If the check engine light is flashing the car is not running on all cylinders. Misfire detected by the ECM/computer. The code for the check engine light is going to be misfire code, that will tell you which cylinder misfired. Need more info as to which powertarin you have (V6 or 4 cylinder) They both have their own bugs. Let me know. Oh. and how many miles on it also.

Jul 26, 2008 | 2003 Nissan Altima

Not finding what you are looking for?
2000 Mitsubishi Eclipse Logo

90 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

79851 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...