Question about 2006 Dodge Caravan
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: starter for dodge caravan 2000
DISCONNECT THE BATTERY, JACK UP AND SUPPORT YOUR CARAVAN. LYING ON YOUR BACK LOCATE THE STARTER WHICH IS ATTACHED TO THE ENGINE THROUGH THE BELL HOUSING .THERE ARE TWO 15 MILIMETER BOLTS THAT HOLDS THE STARTER ON . AFTER BREAKING THE BOLTS A 15MM WRENCH WOULD BE USEFUL.
Posted on May 30, 2008
This is alittle tricky getting to some of the bolts but its not too hard to do otherwise. 2 bolts hold on the starter IIRC they are 13mm bolts. make sure your battery is dissconected by the black cable. then there will be 2 nuts holding on the starter wires. one will be 8mm and the other 13mm. remove them with care cause the wires may and can break. when you remove starter check wires for corrosion or if they look fraigle. repair them if damaged.
then to put it back in is the same way you took it out. should take about 1.5 hrs total if you have never done it before.
Overall i would say skill level 3/10 only cause its trickey getting to that top bolt sometimes.
Posted on Apr 29, 2009
SOURCE: 2006 dodge caravan, 6 cyl.
Firts time swap spark plug & ignition coil between two different cylinders and read again if the same #2 cyl. misfires !
If #2 cyl. is OK and another cyl. misfires then spark plug or ignition coil is out of order and must be replaced.
If #2 cyl. misfires again then #2 injector must be checked !
If ignition coils & spark plugs (complete set for 6 cyl.) are replaced then you must check #2 injector !
Posted on Mar 15, 2010
I just replaced mine and had the same problem. If you look at the new one, you should find a small hole at the base of the metal tube. Using a mirror, I located the same hole in the one in the valve cover and inserted a pointed awl into it and was able to pry it out. Do it slowly since you are prying against plastic. When inserting the new one, I found that it should not be inserted as far the original one was and has a gentle snap.
Posted on Jul 03, 2010
Tips for a great answer:
Feb 18, 2017 | 2006 Dodge Caravan
Dec 09, 2016 | 2006 Dodge Grand Caravan
Nov 15, 2014 | 2006 Dodge Caravan
Oct 14, 2011 | 2006 Dodge Caravan
Aug 17, 2010 | 2006 Dodge Grand Caravan
Jul 26, 2010 | 2006 Dodge Grand Caravan
Apr 28, 2010 | 1997 Dodge Caravan
Oct 13, 2009 | 2006 Dodge Caravan
May 07, 2009 | 1996 Dodge Caravan
May 06, 2009 | 2006 Dodge Grand Caravan
32 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: