Question about 1996 Honda Accord

1 Answer

Were is the ac expansion on 96 accord - 1996 Honda Accord

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 295 Answers

Part of the evaporator good luck.

Posted on Jul 01, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

02 HONDA ACCORD AC COMPRESSOR ONYL COMES ON ON ACCLERATION


This problem can be caused from a malfunctioning expansion valve. This valve is what meters the amount of refrigerant that enters the evaporator as a gas. If this valve fails to go the proper position for refrigerant line temperature, it doesn't convert the refrigerant into a gas, but instead it remains a liquid, and the cooling effect stops. You need to take it to an AC shop so they can check and see if the expansion valve is working properly.

Aug 12, 2013 | Honda Accord Cars & Trucks

1 Answer

Ac expansion valve removel where is it on a 92 honda accord lx 2.2


The valve is located behind the glove box at the inlet to the AC evaporator core.

Jun 21, 2012 | Cars & Trucks

1 Answer

I cannot find the ac expansion orfice tube in a 96 pontiac transport or the location of the expansion valve


LOOK FOR THE ORIFICE TUBE SHOULD BE LOCATED IN THE SMALL REFRIGERANT LINE GOING INTO EVAPORATOR INTO THE FIRE WALL.

Aug 08, 2011 | 1996 Pontiac Trans Sport

1 Answer

How do I change the expansion valve in a 1995 honda accord


YOU HAVE TO HAVE THE AIR CONDITIONER SYSTEM DISCHARGED AT THE DEALERSHIP. OR AIR CONDITIONER REPAIR SHOP.YOU ALSO HAVE TO DISABLE YOUR AIR BAGS.YOU HAVE TO REMOVE THE EVAPORATOR HOUSING TO GET TO THE EXPANSION VALVE.YOU HAVE TO REMOVE THE GLOVE BOX AND GLOVE BOX FRAME.TO GET OUT THE EVAPORATOR HOUSING.REMOVE EVAPORATOR CORE FROM HOUSING TO REMOVE EXPANSION VALVE.THIS JOB IS REALLY A DEALERSHIP JOB.YOUR AC SYSTEM HAS TO BE EVACUATED CHARGED AND LEAK TEST.BEFORE YOUR AC SYSTEM WORK PROPERLY.

Aug 23, 2009 | 1995 Honda Accord

1 Answer

Same problem


Check for ac low pressure switch gone bad.If the expansion valve goes bad it will cause that problem,also, make sure there is enough freon in system.If you could get some one to put ac gauges on the vehicle you could tell a lot about the system,It would tell if the low side was too low(bad expansion valve)or if it was too high on the low side or high side (bas expansion valve or block dryer or condenser.

Aug 07, 2009 | 2000 Honda Accord

2 Answers

95 HONDA AC WILL NOT COOL LOW 60 HIGHSIDE300


most likely cause is expansion valve if low psi side is pulling a vacuum of 10psi or lower that is the problem

Jun 10, 2009 | 1995 Honda Accord

2 Answers

96 Honda Accord LX 4 cyl - ac goes on/off every 15 seconds


when the compressor cycles fast that usually means that its low on freon.use approved gauges to get good pressure readings.

May 05, 2009 | 2004 Honda Accord

1 Answer

96 toyota previa ac cycles on and off.


hi i took my 1992 to panama city central america. i have a overheathing problem whend i turn on my ac ,only send a e.mail to shancito60@hotmail.com to help out thanks

Dec 29, 2008 | 1992 Toyota Previa

1 Answer

Honda accord 96 exi


You need to discharge the AC system and remove the evaporator to replace the expansion valve. No two way about it.

No need to remove the dash

Aug 29, 2008 | 1996 Honda Accord

1 Answer

Replace expansion valve


Hi Tresap,
The only expansion valve that I can think of that you may like to replace is on the air conditioning unit....This valve is found usualy mounted onto the AC unit....You'll have to remove the dash board and centre consul....This is qute a job....You should then see the expantion valve on the cabin side of the AC housing....where the pipes go thru into the engine compartment....NOW HOLD EVERYTHING.....before you can remove the valve you need to depressurize the AC unit....That should be done by an expert....The gas is dangerous and you must wear safety googles at ALL times....Once you have removed the valve, you must seal the system so that as little moisture as possible enters the system....If it is left open, you'll have to replace the dryer unit too....when you've finished your replacement, assembly is the opposite as disassembly.....You'll then need to have the system recharged....Don't try to engage it until that has been done....It wont work even if you tried ,as there are pressur switches which will inhibit the opperation....If you have had practice, it will take about three quarters of a day......if not, three or four days

Hope that this helps you

Best regards Johngee10

Jul 14, 2008 | 1995 Honda Accord

Not finding what you are looking for?
1996 Honda Accord Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...