Question about 2001 Isuzu Trooper

2 Answers

4x4 light is flashing (TOD indicator) - 2001 Isuzu Trooper

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Isuzu Master
  • 450 Answers

This means there is a problem if it continuosly flashes
Short-circuit terminal 8 of the self-diagnostic
connector to GND to display the trouble code on the
CHECK lamp.
If no trouble codes exist, code “12” is displayed continuously.
If trouble codes exist, code “12” is displayed three times, and then other trouble codes, starting from the smaller code number, these are displayed three times respectively.

this is located behind right front centre console side trim..
4x4 light is flashing (TOD indicator) - 2eb44e9.jpg

Posted on Jul 03, 2009

  • atcrane72 Jun 27, 2011

    what do i do? the light is there but i went to 3 different scan folks and the truck checks fine; no codes. is there a rset button or something?

×

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Can you be more specific on the location of this connector? I have a 2001 4WD Trooper, and cannot find this connector. Is it just hanging loose somewhere under the dash?

Posted on Jan 12, 2010

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

c1apton15
  • 3400 Answers

SOURCE: TOD Check light? My check

Have a local shop or auto parts store perform a "Fault Scan" - Most good auto parts stores will do it for you for FREE. They read the codes, print out what is wrong and reset your lights.

Posted on Jan 05, 2011

  • 11 Answers

SOURCE: 4X4 green inidcator light flashes and ABS light

Hi, you will probably have to take to mitsubishi dealer and have them scan diagnostics....but sounds like the o ring has busted in transfer case. will it shift in and out of 4wheel drive? If not don't drive it...it will cause alot of damage.

Posted on Aug 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Orange light flashing on right hand side of the dash on a1997 ford explorer what does it mean


Check 4x4 wiring underneath the car. If the flashing light is labeled 4x4 it usually indicates damage to the wiring under the vechile

Nov 04, 2016 | Ford Cars & Trucks

1 Answer

Why my 4x4 light is flashing?


got the PT 4wd system?
or the TOD system.?
left dash cluster, see graphic of wheels etc.? that is TOD
we cant guess drive lines here. all are optional day one made in Japan.

if part time , its for ice only or offroad, never dry pavement.
are you? on dry pavement? cant guess that either.

Oct 28, 2015 | 1999 Isuzu Trooper

1 Answer

Why is my od panel flashing green on back wheels


Have your owners handbook? The TOD system is explained in that and may offer an answer. Its a traction on demand system (TOD) and will have sensors and switches. I believe it runs the back axle at normal conditions but switches to both axles when traction is low or lost. If you haven't a handbook you might find one online for down load or just to read or it would be in a manual like haynes or chiltons.

Aug 26, 2014 | 1999 Isuzu Trooper

2 Answers

1998 ford explore 4x4 high and 4x4 low lights flash 6times then stop


Hi Slilbit, Take the vehicle for a diagnostic scan. The flashing light is indicating a problem with the transmission. Regards John

Sep 02, 2012 | 1998 Ford Explorer

1 Answer

Tod system on 98 bighorn check light and rear wheels flashing on dash when ingnition on and stays on not pulling front diff out of ingagement vsv are ok and work no power at them but have earth on both so...


check out detent limit switches on gear box and transfer case for continuity and open circuit when pressed(on /off switch) these are feed back signals to indicate it has locked into 4x4 or 2x4, if one of these dont work properly system locks up and wont do anything any more. also check front one on diff near actuator, common problem. check actuator is working properly when vacuum applied and removed. can remove this and bench test unit,some oil will be lost when removed for bench test and you can check colar inside diff slides back and forth to lock axle.

Aug 30, 2011 | Isuzu Trooper Cars & Trucks

1 Answer

TOD Check light? My check light under the TOD keeps flashing on and off. Please help me what should I do?


Have a local shop or auto parts store perform a "Fault Scan" - Most good auto parts stores will do it for you for FREE. They read the codes, print out what is wrong and reset your lights.

Jan 05, 2011 | 2001 Isuzu Trooper

1 Answer

On my 1999 Trooper TOD is flashing and the red Check light is flashing. We just had a large amount of snow and I used the 4 Low to get out. That is when this started..


I am not sure what the problem is, but I do know if the check engine light is red, and flashing it indicates that whatever the problem is it's DOING DAMAGE. I don't recommend starting this vehicle until the problem is solved.

Dec 13, 2010 | 2001 Isuzu Trooper

1 Answer

Indicator for 4x4 wont stay lit


that is why the light flashes and goes off, it times out, the transfer case actuator motor has most likely failed or there is damage to the wiring to the transfer case, go under the truck and chack for wiring damage at transfer case which is at reat of the transmission.

Jan 07, 2010 | 2004 Ford F150

2 Answers

Tod problem


check the sensor under truck on the front of transfer box... if tod is not lite up on dash check relay and fuses

Dec 29, 2008 | 2002 Isuzu Trooper

1 Answer

My 01 Trooper had problems with the TOD starting last winter. When the switch on the dash is engaged the TOD indicator flashes continually at 4hz but the check lite does not come on. I have vacuum at the...


We have a 1998 Trooper that had the same problem. The fix was an electronic switch for the 4WD - a vacuum sensor - on the front axle that just plugs in. You can see it - if you look under the car from the front, it's mounted in the middle of the front axle. It cost $175 from the dealer. We had somebody install it for $50. Don't know where you live, but they are exposed and can corrode. That's what happened to ours. Good luck - hope it's the same problem. This was an easy fix, and we were pleased.

Jul 20, 2008 | 1998 Isuzu Trooper

Not finding what you are looking for?
2001 Isuzu Trooper Logo

1,218 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...