Question about 1995 Jeep Grand Cherokee

1 Answer

Blower motor 95 jeep Cherokee

Blower motor work only on high Low Med don't work 95 jeep Cherokee

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Hi Craftsman,
I suffered a similar failure on my little Rover. I think you will find out the resistor on the blower has had it. It is probably similar in theory. The resistor block contains several resistors. As you alter the blower speed, different resistors are used. One of yours has obviously failed. You need to replace the resistor block, which may be located at the back of the engine bay, on the passenger side, under the wiper module. Or you can remove the resistor block and replace the failed resistor - a competent auto-electrician can do this, or advise you how to.

Posted on Jun 30, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ac blower motor stopped working


YJ car.
the blower is dead. is that it?
does it blow full speed on high
do you have 12v on terminal A of blower , term B is 0v ground
got that, then the blower is dead.
if not 12v, then the controls are bad.
http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service

page 47
4 parts to make blow
1: fuse 12 good.
2: switch heater /on off.
3: high, med,low speed, use high, its direct.
4: the blower,
one of those points has no 12v on high,
use a simple voltmeter to find the failed point.

Jan 14, 2014 | 1994 Jeep Cherokee

1 Answer

My A/C doesn't work on 1, 2, or 3. It only works when the selector switch is set to high. Any ideas?


There's 2 relays that control the blower motor, one runs low and medium speeds and the other runs the high speed. Replace the relay for the low and med speeds.

Jan 04, 2011 | 2008 Jeep Liberty

2 Answers

2005 grand cherokee blower motor only runs in high no med or low speed,


Change your blower motor resistor, usually that is the last one to go out is high. Also be sure to check your fuses as a just in case.

Aug 03, 2010 | 2005 Jeep Grand Cherokee

1 Answer

Blower motor only goes on high but low and med dont work at all


Check and/or replace the power motor power module located oon the blower housing.




5ba5a0f.gif

Jul 21, 2010 | 2005 Jeep Wrangler

2 Answers

Have a 2003 Jeep Wrangler, Rubicon and the hear/AC blower fan only comes on in the high position. The other setting low, med and med/high the blower will not come on. Is this the controller it self?...


The problem usually stems with the blower motor resistor,high speed by-passes it and there-fore the controller is sending power but the resistor has gone open and the speeds can't be regulated.

Feb 08, 2010 | 2003 Jeep Wrangler

1 Answer

My 95 jeep cherokee heater switch on ly works on high


I would try to replace the blower motor resistor first,If that doesnt repair your problem you may wanna try replacing the blower speed switch.The resistor is located under the passenger side of the dash mounted in the heater box.

Jan 30, 2010 | 1996 Jeep Grand Cherokee

2 Answers

1994 jeep grand cherokee heater only works on high


U need to replace the blower motor speed control resistor.

Feb 25, 2009 | 1995 Jeep Grand Cherokee

1 Answer

Heater and or A/C blower fan not working in Low, Med or High position


please check the resistor block. this is the part that controls the speed of the fan motor. it is usually found in the blower housing or in the evaporator housing. it has 4-5 wires on it and the last big blue wire normally goes straight to the blower motor. there should be resistance on all pins of the resistor block.

good luck .

tnx 4 using fixya,

drcool

Nov 10, 2008 | 2000 Jeep Cherokee

1 Answer

94 jeep cherokee ac blows cool on medium only. recent recharge freon help cool more.


could be anything overcharging the system, freon leak faulty componets like compressor or clogged lines or orfice tube or dirty evap. coil check for 12 volts comming into the blower motor with ur switch on high if ur getting 12 volts at the plug then replace ur blower motor

Jun 21, 2008 | 1994 Jeep Grand Cherokee

Not finding what you are looking for?
1995 Jeep Grand Cherokee Logo

479 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...