Question about 1999 Suzuki Vitara

1 Answer

Door handle spare part

Where can i find a door handle for my suzuki vitara 1.6?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 321 Answers

THE ONLY PLACE TO GET THAT FROM IS THE DEALER OR THE JUNK YARD.
I DO NOT KNOW WERE YOU ARE OR I WOULD HAVE GIVEN SOME PLACES TO GET IT.
HOPE THIS HELPS
THANK YOU
JM

Posted on Jun 30, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Problem reprogramming romote door locking transmitter.After reprgraming has been successfully done it fails to lock/unlock doors. My spare romote works ok


did you follow the books steps carefully
and read the rules on key counts
the book , operators guide tells all this, rules and DIY key learning,

lost the book , its free at Suzuki
or $4 here
USA only
RTM
https://suzukipitstopplus.com/Products/1044-2006-grand-vitara-owners-manual.aspx

Mar 07, 2017 | Suzuki Cars & Trucks

2 Answers

How to remove door panel from 2006 suzuki grand vitara


The door is afixed with push pins.

Remove the screw that secures the pull handles, then use a thin device between the door panel and the metal frame. slid until you are close to a pin and then apply outward pressure.
Best to start at he bottom or lower outer edge...once the bottom and sides are loose, lift the panel verticaly to release top edge...

Jun 29, 2015 | 2006 Suzuki Grand Vitara

1 Answer

2004 Grand Vitara. Warming the car this morning, locked it.Came back with remote and a key and the doors would not unlock.Engine was running with the other key in it. Had to have a locksmith break in. Why...


don't have 2 fobs?
it cam with 2,
and the battery must be good.(for buttons to work on fob)
never run any car with only 1 fob or one key.
or get locked out.
are you saying the metal cut key end (pure mechanical ) failed?

my car has a real key with a a transponder inside .
it can open 2 ways, the keyfob buttons, (takes a good battery)
and the key metal end.

get a spare fob and program it.
http://blog.keylessentryremotefob.com/2013/07/2008-suzuki-grand-vitara-key-fob-remote.html

now you have 2 like you should.

Feb 07, 2014 | 2009 Suzuki Grand Vitara

1 Answer

How to replace a 2003 grand vitara's rear door handle


1. open the rear door
2. open the rear door sidings
3. try loosing the not of the handle
4. remove the steel wirings of the handle
5. install the new rear door handle

Jul 15, 2009 | 2003 Suzuki Vitara

1 Answer

How i remove the door panels from a suzuki grand vitara 2007?


You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Mar 04, 2009 | 2007 Suzuki Grand Vitara 4WD

1 Answer

Rear door light is on (SUZUKI VITARA)


The light button to the door is not pushed in enough to turn off. Tape it up or just may need a little WD 40, from just sticking.

Dec 07, 2008 | 2001 Suzuki Vitara

1 Answer

Rear door handle


I had to do the same hting for my 2001 vitara
for me i had to do it from the inside of the car
i had to take of the entire panel under the rear window which was pretty much all just snaps so it was pretty easy

Nov 11, 2008 | 2004 Suzuki Grand Vitara

1 Answer

Suzuki grand vitara rear door handle fitting


How do i remove the tail gate door panel on a suzuki gran vitara as i have to replace a broken door handle?

Aug 03, 2008 | 2003 Suzuki Vitara

2 Answers

Removing rear door liner to fit new handle


hi there undo the phillips screw inside the handle the gently slide the whole handle outer casing to the right about 1 cm, it will help if you push it into the door as you do it to give it a little bit of help the feed the whole mechanism through the hole in the panel hey presto!

Aug 03, 2008 | 2003 Suzuki Vitara

2 Answers

Intermittent light on dash,


the indicator is for any ELECTRICAL problem with the car .so get the electrical system checked especially the ALTERNATOR.for proper charging .

May 19, 2008 | 1999 Suzuki Vitara

Not finding what you are looking for?
1999 Suzuki Vitara Logo

Related Topics:

133 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...