Question about 1994 Ford Aerostar Extended

1 Answer

I have a 94 ford aerostar the starter hung up and the the motor just shut off. now we have put on a new stater and the van will not do nothing????

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 379 Answers

Probably melted a fusible link for the ignition circuit or fried a relay. Check all your fuses, especially the high amp ones. Do you have power to the starter when the key is in the "start" position? If not, check the fuses and cables. You sure the battery is not dead? Do the lights come one?

Posted on Jun 30, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

We have a 1990 Ford aerostar minivan and the blower motor isn't working. I don't know where the resistor is or where the blower motor is located. Anyone know?


Blower motor is in dashboard. Problem could be with motor windings, bearings, fuse, relay, and switch. Check them all out.

Nov 13, 2015 | Ford Cars & Trucks

1 Answer

Battery charged but wont start


Have battery load tested if it checks good remove starter and have it tested to see how many amps it is pulling I think you will find one or both of these to be your problem. Make sure cable going to battery and stater and negative cable have good clean connections and cables are not corroded. If this helps please give me good feed back.

Apr 13, 2013 | 1995 Ford Aerostar

1 Answer

My1997fordareostar van will make a clicking noise but i still have all power in battery what is the problem


A click every time you activate the starter motor generally tells us that the solenoid is working fine, but that the starter motor is faulty and requires repair/replacement.

To just double check:

Turn on the headlights when cranking.
If the lights dim significantly, then the battery doesn't have enough charge to power the starter, and the battery could require replacement.
If the lights don't dim by much, then the issue is most likely the starter motor.

Nov 12, 2012 | 1996 Ford Aerostar Extended

1 Answer

Starter problems for 88 ford aerostar van 7 passenger. how do i know its the starter or bad connection?


Test your battery and starter by doing a voltage drop test. Put one test lead of your meter on the neg side of your battery, one on the positive. Check voltage. Make sure that you are actually connecting to the battery itself and not the terminal ends. Should read 12.8-13.2. Keeping the neg in the same location move the pos to the terminal end, engage starter, meter should read above 10 volts. Continue testing down the pos wire to the starter, checking voltage, until you find less than 10 volts. If the voltage is good at starter, have someone turn key to the start position, tap starter with a hammer. if starter engages , replace starter.

Aug 19, 2011 | 1988 Ford Aerostar

2 Answers

Brakes wont work pedal goes to floor changed the master cyclinder bleed brakes and still have same problem 1990 ford aerostar van


What is the condition of both front calipers? both rear wheel cylinders? and the complete brake lines and hoses of your van? If they are all good with no traces of leakage, then did you bleed the Mastercylinder on the bench first before installing in the van? Did you gravity bleed the 4 wheels first? did you bleed from the farthest wheel first? Are you using a new Master and not a re-built??

Feb 25, 2011 | 1990 Ford Aerostar

3 Answers

I bought a used 94 ford aerostar w/ no manual- need to fix power window-need driver's side fuse diagram


usaly the all run off same fuse and relay so most likely u will have to replace window motor

Oct 08, 2009 | 1994 Ford Aerostar Extended

1 Answer

'90 ford 350 won't turn over


The windings in your starter motor have burnt out the only thing you can do is change the starter motor.Good luck hope that was helpfull

Aug 01, 2009 | 1990 Ford F150

1 Answer

Tire size?


My 94 aerostar requires P215/70R14SL tires.
Air pressure: front 32 PSI cold - rear 35 PSI cold

Mar 28, 2009 | 1994 Ford Aerostar Extended

Not finding what you are looking for?
1994 Ford Aerostar Extended Logo

Related Topics:

172 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...