Rear cup holder came out on a toyota 2008 corolla

SOURCE: replace rear seat belt in 1993 Toyota Corolla

OK. On the front edge of the seat bottom cushion, pull up hard, both sides. This will dislodge the 2 clamps that holds the seat cushion to the floor. Pull the seat cushion out & set it aside. You will now see the female latches bolted to the area where the rear of the seat cushion meets the rear seat back bottom. Remove the bolts (14 mm I think).

SOURCE: Reset the maintenance required light on my 2008 toyota corolla

OK ON YOUR SPEEDOMETER, THERES TRIP A, TRIP B, AND THE REGULAR ODMO... U NEED TO PUT IT ON TRIP A (WITH THE KEY OFF) ONCE U GET IN ON TRIP A, PUSH AND HOLD THE BUTTON DOWN,WHILE HOLDING BUTTON DOWN TURN KEY ON, YOU WILL SEE LINES POP UP ON THE ODOMETER, (WHERE THE MILES ARE DISPLAYED) THEY WILL GO OUT ONE BY ONE, ONCE IT STATES 0 YOU ARE GOOD TO GO.. GOOD LUCK AND THANK YOU FOR USE FIXYA.COM..KEITH..

SOURCE: 2008 toyota corolla

Should have to turn off the key, press the odometer reset button, while holding it down, turn ignition on, not starting the car, wait for the light to reset, or show counting down in the odometer.

SOURCE: cup holders for 1997 toyota 4runner

Try a local scrap yard...much cheaper there.

SOURCE: 2008 Toyota Corolla

Hello, i have enclosed a routing diagram for your corolla! Hope this info is useful to you and have a great weekend!