Question about 2004 GMC Envoy

1 Answer

A/C does not work on 1-4 but works on 5.

I replaced the blower resistor and still have same problem. Is their a a/c resistor located on a 2004 envoy xl?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • GMC Master
  • 6,927 Answers

If u replaced the blower resister,then ur fan speed switch is bad

Posted on Jun 30, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 ENVOY WHERE IS MODULE RESISTOR


2002 - 2009 GM BLOWER MOTOR RESISTOR - YouTube

? 4:17
https://www.youtube.com/watch?v=WWi-_-kY-dM
Sep 5, 2012 - Uploaded by davesgarage512
I have a 2003 GMC Envoy and my issue is when I shut the blower off it still ... Can this issue also be remedied ...

2004 GMC ENVOY Blower Motor Control Module / Resistor



Nov 28, 2015 | 2004 GMC Envoy SLT

1 Answer

Blower motor intermittent failure


Change your blower motor resistor, common problem, where certain speeds will work intermittently and eventually complete failure. Located under the dash behind the glovebox. My #5 just quit working, I will be doing this tomorrow. My last TB, same thing happened. My neighbors TB same problem, only her female connector was melted that plugs into the resistor. My current TB is melted too, so I need to replace the connector and the resistor. This problem is so common in TB's and Envoys, it should be a recall.

Jan 03, 2014 | 2004 Chevrolet TrailBlazer

2 Answers

Fan does not operate on the 1, and 2 settings. It does run on the 3, 4, and 5 settings.


I have had several gm vehicles over the years it seems to most always be a faulty fan switch. The truck I own now only works on high

Jul 01, 2011 | 2004 GMC Envoy

1 Answer

I have a 2004 GMC Envoy XUV and the blower motor only works on high. I would like to repair, please help


Hi, it is likely the relay in the resistor assembly has failed. Replace the resistor assembly.
To access the assembly, remove the right closeout/insulator panel (above the passenger's feet). Then remove the Instrument panel storage compartment door. The resistor looks like the pic below and is screwed into the heater box. The wires shown connect to the blower motor, and another 5-wire connector from the control panel is plugged into the resistor. Take the connector off and unscrew the resistor to replace. Please let me know if you have any questions, and thanks for using FixYa.

    jturcotte_520.jpg

Jun 11, 2011 | 2004 GMC Envoy

1 Answer

Htg and a/c fan switch only works on high in 2004 GMC Envoy. The a/c and heat work, just the blower only blows on high


Sounds like the blower motor resistor module is bad. It is located behind the glovebox and mounted to the blower motor. Open the glovebox and in the back left corner find a spring, push on spring to release glovebox door completely. You should be able to see blower motor and resistor module.

May 13, 2011 | 2004 GMC Envoy

1 Answer

What causes the blower motor on a 2004 gmc envoy not to work on high ( setting#5) it goes off but if left on 123or4 it works fine


there is a bank of resister coils in the hvac box that houses the blower motor it will have two screws and a long conector with four or five wires replace this its called blower motor speed control resistor

Jan 14, 2011 | 2004 GMC Envoy

1 Answer

My 2002 GMC Envoy xl fan switch has 5 levels but the fan only works on levels 4&5. I heard there is a switch under the dash in the duct line, but I don't know what I'm looking for.


Your looking for the blower resistor. Its on the passenger side under the dash. Two of the wires go the the blower motor. The wire connector and the resistor can burn or corrode. The replacement is easy two screws hold the resistor in and the connector can be replace with **** connectors.

Dec 12, 2009 | 2004 GMC Envoy

2 Answers

The blower speed switch only works on 5. The


this problem is caused by a defective blower speed control resistor, it is located near the blower motor, very cheap to replace, part is around $35

Oct 26, 2009 | 2002 GMC Envoy

1 Answer

I have a climate control problem on 2004 gmc envoy, it's climate control's fan is not working at level 1-3


The likely problem is the blower motor resistor pack is defective. It is located behind an access panel below the glovebox. Go to www.trailvoy.com and do a search on "blower motor resistor replacement"

Oct 26, 2009 | 2004 GMC Envoy

2 Answers

Envoy Resister


no resister on this car. the a/c comtrole is a module. comtrol the blower. frist check the connetor for the blower. if is ok replace the controler. price for $ 200.00 call the deler

Apr 17, 2009 | 2004 GMC Envoy

Not finding what you are looking for?
2004 GMC Envoy Logo

Related Topics:

236 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...