Front drivers side window wont go down and mirror wont go up or down

That is more that one item causing that. You need a good auto-electrician with a scan tool computer or the dealership.

sounds like you have lost power to driver side control box sometimes the electrical connector comes loose or fuse may be blown for power windows, mirrors.

replace the master switch on the drivers side door most are computer controlled

Most likely you have to replace the switch assembly on the driver side it probably got wet over the years from rain and snow and cause it to short out. Do not get a used part from a scrap yard because your end up with the same problems.

The power windows on your vehicle are controlled by an electronic control module , as are the power mirrors !
Power Window System Components
The power window system consists of the following components:
• Driver door module (DDM)
• Passenger door module (PDM)
• Body control module (BCM)
• LR power window switch
• RR power window switch
• Window up and window down relays in each of the rear passenger window switches
• Window lockout switch
• Reversible power window motors in each of the doors (circuit breaker protected)
• LT DOOR CB 25A (System power for left rear window)
• RT DOOR CB 25A (System power for right rear window)

Your best bet , take your vehicle to a qualified repair shop.

drivers side module not working front windows dont go down

I have the same problem. Do not know cause but I remove large red 50 fuse in engine compartment fuse box, wait 15 sec and replace. Lock car and unlock. This seams to reset something and car is fine. This problems seams to appear when my battery is low.(?)

Outside Mirrors REMOVAL & INSTALLATION Standard

1. Remove the door trim panel and detach the inner panel water deflector. With the glass in the down position, pull out the front portion of the glass run weatherstrip. Fig. 1: Unfasten the attaching nuts from the mirror base studs, then remove the mirror

1. Remove the attaching bolts and screws from the front glass run channel lower retainer to filler, then rotate retainer rearward.
2. Remove the noise control patch to gain access to the screw at the belt, then remove the screw.
3. Remove the filler attaching screws at the top front of the window frame, then remove the mirror and filler from the door.
4. Remove the attaching nuts from the mirror base studs, then remove the mirror. To install:
   
5. Be sure that the mirror gasket is aligned.
6. Replace the mirror and filler on the door. Install the filler attaching screws at the top front of the window frame. Attach the nuts to the mirror studs and tighten.
7. Install the screw at the belt, then insert the noise control patch.
8. Insert the retainer, then install the attaching bolts and screws to the front glass run channel lower retainer to filler.
9. Replace the front portion of the glass run weatherstrip, insert the inner panel water deflector, then reinstall the door trim panel.

Manual Remote

1. Remove the mirror remote control escutcheons and door trim panel. Detach the inner panel water deflector. NOTE: Right side remote mirror may require detaching part of the instrument panel.
   
2. With the glass in the down position, pull out the front portion of the glass run weatherstrip.
3. Remove the attaching bolts and screws from the front glass run channel lower retainer to filler and rotate retainer rearward.
4. Remove the noise control patch to gain access to the 0.3 in. (7mm) screw at the belt and remove the screw.
5. Remove the filler attaching screws at the top front of the window frame.
6. Remove the mirror base with mirror and cable assembly from the door.
7. Remove the mirror to filler attaching nuts and remove the mirror and cable from filler. To install:
   
8. Be sure cable is routed around front glass run channel retainer and installed to clip.
9. Install and connect the cable to the filler.
10. Attach the filler nuts to the mirror, then tighten to 72 inch lbs. (8 Nm).
11. Install the mirror base with the mirror and cable assembly to the door.
12. Insert the filler attaching screws to the top of the window frame, then install the screw to the belt.
13. Secure the noise control patch.
14. Attach the bolts and screws to the front of the glass run channel lower retainer and filler.
15. Install the glass run weatherstrip.
16. Attach the inner panel water deflector, door trim panel and mirror remote control escutcheon.

Electric Remote

1. Disconnect the negative battery cable.
2. Remove the mirror remote control escutcheons and door trim panel. Detach the inner panel water deflector and the electrical connector for the mirror. NOTE: Right side remote mirror may require detaching part of the instrument panel.
   
3. With the glass in the down position, pull out the front portion of the glass run weatherstrip.
4. Remove the attaching bolts and screws from the front glass run channel lower retainer to filler and rotate retainer rearward.
5. Remove the noise control patch to gain access to the 0.3 in. (7mm) screw at the belt and remove the screw.
6. Remove the filler attaching screws at the top front of the window frame.
7. Remove the mirror base with mirror and electric connector from the door.
8. Remove the mirror to filler attaching nuts and remove the mirror and electric wire from filler.
9. To install, reverse Steps 1 through 6. Be sure electric wire is routed around front glass run channel retainer and installed to the clip. Tighten the nuts to 72 inch lbs. (8 Nm).
10. Connect the negative battery cable, then reset the clock, radio and any other accessories if required.

is this on BOTH windows?? it is odd they both failed at the same time.
If you here the motor running there is something inside the door has let go or falling off. the door will have to be taken apart to be fixed.
this is what's inside YOUR door. (passanger side, drivers side is just a mirror image)
1. there could be a problem between the motor gear and the moon gear. or 2 (most likely) the regulator arm has come off the window track or the window track has come off the glass.
hope this helps.

I had the same problem with now power to windows, mirrors and seat. The common soulution is the orange and or black wire in the boot have broken between the door and post.