Question about 2005 Volvo S40

2 Answers

FOCUS 1.6 ZETEC CLIMATE TDCI 2006- FAULT CODE P242F

ENGINE LIGHT WAS ON AND INLET PIPE HAD BLOWN OFF - REMOVED INLET MANIFOLD TO FIND IT HAD SPLIT.
REPLACED INLET MANIFOLD BUT DIAG STILL SHOWING SAME FAULT.
DEALERS ADVISE FUEL REGENERATION?
COULD IT BE THE CAT BLOCKED?

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,185 Answers

If the cat was blocked you would have noticed a massive power loss and your speed would have been down to - 40kph

If that was the case then yes the cat has collapsed and needs replacing

Posted on Jun 30, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Where is the bolt located under the vehicle to remove inlet manifold

Posted on Nov 18, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ford focus c-max 1.6 TDCI ZETEC 2006 auto timing belt or timing chain ?


MY information shows a 1.6 engine as a rubber belt
check the timing housing area and if it is all plastic then it will be rubber
if it is all aluminium then it will be chain.

Feb 04, 2015 | Ford Cars & Trucks

1 Answer

Diesel particle filter /system cleaned and put in 2 lts of fluid but light in dash will not go out


sure , read the FSM.
go to Ford, , parts counter and buy the Factory service manual.
on my car 08 , its on CD and is 7000 pages. long.
make sure its covers the Diesel option.
some (many) makers of cars, alternate engine options have
SUPPLEMENTS. ask em'
what country are you in, or where was car sold to.
see the diagnostic pages for your DTC errors and all tests to do.

second gen, Focus engine; line up, WHICH ONE>?

1.4 L I4 Zetec-SE
1.6 L I4 Zetec-SE
1.6 L I4 Zetec-SE Ti-VCT
1.6 L I4 Diesel TDCI
1.6 L I4 Diesel TDCI DPF
1.8 L I4 Duratec HE
1.8 L I4 Diesel TDCI
1.8 L I4 Duratec HE FFV (Flexifuel vehicle)
2.0 L I4 Duratec HE
2.0 L I4 Diesel TDCI
2.5 L I5 Turbocharged T

diagnosing any engine.
step 1 is engine
and step 2 is blown fuses.
and step 3 is read the TSBs on your car. (tech .serv. bul)

Jul 10, 2014 | 2006 Ford Focus

1 Answer

Control imrc circuit open


Never heard of this before but no doubt i will get a newer car in sooner or later

Dec 18, 2013 | 1999 Ford Windstar

1 Answer

My check engine light is on and my car seems like it may stall out. Like it is idling too low. But it doesn't seem to be the spark plugs?


check the breather pipe on the bottom of the inlet manifold ,difficult to see anjd reach (zetec engine) these split and perish causing idle problems

Sep 19, 2011 | 1998 Ford Escort

1 Answer

Are there any leads on a turbo on a focus tdci estate 04.it has sudenly packed up after the starter motor was replaced


Dont think their are any wires that i can remember ,Yes their are wires and a sensor on the air intake -- most likely cause is the intake pipe isnt fitted properly so the sensor isnt measuring the air flow ,or the pipe from the turbo to the inlet manifold is off

Jan 02, 2010 | Ford Focus Cars & Trucks

1 Answer

Problem when i have to restart my car


hi could be a number of things like your deisel is dropping back. sounds like injectors and even this would not show on computer if they have a back leek.. you can get them tested but it about 20 pound per injector so be aware also if you take them out as a must the must go back in the same pot as they come from or get them recoded wen u put them bk in

Jun 10, 2009 | 2006 Ford Focus

1 Answer

1998 escort 1.8 zetec hesitates when warm somtimes


could be any of the following
1, worn ,faulty or incorrectly gapped spark plugs
2, engine management fault
3, vacuum leak at the inlet manifold or associated hoses

Apr 27, 2009 | Ford Focus Cars & Trucks

1 Answer

Oil filter location tdci engine


Try looking under the inlet manifold. I know the ford mondeo uses a cartridge one ...could be your's the same but you'll find the cover is a round one and looks like an oil fliter if it's a cartridge tyep. cheers

Feb 08, 2009 | 2005 Ford Focus

Not finding what you are looking for?
2005 Volvo S40 Logo

Related Topics:

1,031 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...