2004 Subaru Forester Factory Service Repair Manual INSTANT DOWNLO
visit the link to get your solution
SOURCE: 2001 subaru forester rear wiper motor replacement
Hi, it is pretty straightfoward (ahem, you know how this can go. depends on whether your wiper arm retaining bolt is frozen and snaps off the shaft or not). First, take a look at your fuse to make sure it is intact. If it is, just gently pop off all of the plastic trim covering the tailgate, and undo screws too as necessary. Then test the connector wires to be sure you are still getting power back there to the motor, I used a $4 test light that I got from AutoZone. Then use a large philips head screwdriver and 10mm socket to remove the whole dang thing.
SOURCE: subaru legacy sunroof wont open but motor turns
Same problem mine will only work when it is warm out because of the gasket. When there is the slightest difference in colder temperatures I need to press on the top of the sun roof while hitting the button to have it slide. Using the gasket cleaner may be a good idea. I haven't tried that yet though so don't take my word
SOURCE: 2004 Subaru Forester
If the '04 has the same setup as the '00, then there should be a switch on the top of the steering column that will turn the parking lights on or off even if the key is removed. Hope this helps.
SOURCE: Subaru Forester window air leak
take out the tweeder covers if you have tweeders or remove the triangle covers were the tweeders woud be ,then stuff a klittle foam in their,worked for me
SOURCE: Procedure for replacing rear wheel bearings 2000 Forester
i'm assuming you don't have a hubshark,this is a tool that will alllow you to remove the bearing while the knuckle is attached to the car,you may be able to rent this tool at a auto prts store .if not you need to remove the entie knuckle,first remove the trailing arm bolt,then the lateral link bolt{long and stubborn bolt},disassemble the brake shoes and parking brake cable,abs sensor if equipped the knuckle to strut bolt{no marking necessary they are not eccentric} then you need a to use or borrow a press to remove hub and bearings good luck
145 views
Usually answered in minutes!
×