SOURCE: how to remove rear door panel on 2002 chevy blazer
usually two screws one at the armrest and one under the power window console , this console usually pops out to let you at the screw.
SOURCE: 1999 chevy blazer distributor cap diagram
need 8th digit of vin and engine size, email address to send diagrams to you
SOURCE: i am wondering how do you put a 2002 chevy s10
if you did not rotate the engine, you put it bsck in the EXACT place it was when pulled out. If you did not mark it, you will need to get #1 Cylinder on TDC and put it in, it should run, but you will need a scanner to set the rotor position (cam ******) to ZERO The distributor does not alter the timing
SOURCE: how to install a distributor in a 2002 chevy
Gonna do my best to explain it to you. See diagram below to refer to what I am explaining. You will need to take the number 1 cylinder spark plug out. Making sure your coil wiring is disconnected have someone in the car turn the key on and off for a brief second (tap it). As they are tapping the engine over you will want the piston in the number one cylinder to be at the very top. You may need to insertt a screwdriver in there to feel if it is up at the top but don't leave the screwdriver in there as the are tapping the emgine as it may get jammed in there and cause damage. So after they tap it feel down there with your screwdriver to see if it has moved up until you are sure it is at the very top of the cylinder wall. When it is at the top you should be at top dead center (TDC). Now as you put insert the shaft of the distributer into the engine the gear at the bottom of the shaft will turn the shaft. You want to insert it as it turns to where the rotor will be facing where the number 1 tab of the distributer cap is located. This may tatke a couple of tries to get it right but you will get used to how it rotatetes as you insert the distributer and make the ajustments to get it right. I think you will understand more as you do it then just what I am writing. Once the rotor is facing the number 1 spot on the cap you should be all set as far as how the distributer goes in. You will then need to set the timing once you get it running. I hope you were able to understand as I am not the best at explaining things. I hope this helps you and good luck. Here is your diagram.
99 views
Usually answered in minutes!
×