Ive got 2000 gmc savanna van wood like to now if has remote door locks
SOURCE: i cannot remotely lock the
I had the same problem - ended up having to replace the entire fuse panel due to a short in the system. I haven't had the problem since the fix.
SOURCE: Door locks not working 2000 GMC truck.
you will need to remove the door panel to get to the actuator, there is probably a clip that has either broken or popped out
SOURCE: 2000 GMC safari Power locks will not work + cant unlock back door
This could be a problem with your primary switch in the driver's door. Everything passes through that switch. Verify voltage continuity to the switch (Haynes or Chilton will give you a conclusive wiring schematic), and you must also verify that the switch itself is not faulty. Using a DMM (digital multi meter), measure the resistance (ohms) between 2 contact points, then hit the switch and verify that this number increases.
SOURCE: can I bypass the heater core in the rear of my 99 Savanna?
Yep. Just get a piece of copper tube or an elbow and substitute it for the heater core anywhere it's easy to get to.
SOURCE: where is the ac lowside port located on a 2005 gmc
The low side port of the 2005 GMC savanna Van is located on the low pressure side of the compressor.
This is found by locating the compressor driven by a belt that has a clutch that engages and disengages as the a/c cycles.
The low pressure piping is always in the larger diameter piping, and the high pressure side is always contained in the smaller diameter piping.
Therefore, follow the thick pipes from the compressor up to the accumulator, which looks like a large can of soup. On the accumulator receiver/drier is a port that connects to the tube that is connected to the can of r134a freon refrigerant.
Simply quick connect the tube to the low side port, which is located on the 'thick' tubing or on the accumulator and then fill until the low side pressure is 25 psi to 45 psi while the compressor is running.
When the car is off and the compressor is not running, the pressure should be 75 psi to 100 psi on a hot day.
Hopefully the system doesn't have a leak slow or fast in it.
97 views
Usually answered in minutes!
×