1993 BUICK HAS SPARK FUEL WILL NOT START

It could be a lot of things. Do you know for certain it has fuel in it? Have you checked to see if it has spark? Have you tried using starter fluid? If it tries to run on starter fluid, then you have a fuel issue. If it doesn't try to run on starter fluid, it is likely a spark issue. It is not uncommon for the ignition control module to fail on these cars. If you can remove it, Auto Zone and other retailers can test it for free.

is the check engine light on?if you have no spark, start with the wires, and work your way back. you say that you replaced the coil packs..... it could be a crank position sensor. please get back to me if the check engine light is on. also, let me know what happened from the start. were you driving? has the car sat for a while?

it could be your starter, fuel pump went out, clogged fuel filter or you might not have spark.do it got the check engine light on

crank position sensor, camshaft position sensor or an injector with too many ohms resistance. when you turn the key to the on position you should hear the fuel pump come on for a few seconds. if not suspect fuel pump relay or fuel pump

you will need to determine if it's a no spark issue or a no fuel issue.

When the car wont start spray some carb cleaner or starter fluid into the intake and try to start. if it does start and run for a few second then the problem is with the ignition side

check for spark by removing a spark plug lead from a spark plug and putting a good spark plug in the wire, use a jumper cable and clamp one end to the spark pug thread and the other to battery ground. Turn the engine over and you should see spark.

is the check engine light on? if so get the computer scanned, autozone will do it for free

could be the fuel pump

Check a few things, check your spark plugs, spark plug wires, also check your fuel filter, fuel pump, but the first thing that you should check is the ground wire from your battery to the engine block

replace the ignition module,under the coil pack.

crank and no start could be several reasons, 1 no spark going to the spark plugs, 2 possibly no fuel or that the injectors not working 3 could be a timing belt or . chain problem

ck the crank position sensor. It's on the front of ehgine at the crank pully. If there seems to be a fuel problem, ck the maf sensor. first sensor out of air cleaner. good luck

You have checked for spark, Fuel Pressure, Injection pulse? Don't worry it will run. It was made by the General!