Question about 1999 Chrysler Concorde

1 Answer

When i press the gas the car gives a rough clicking noise

My check engine light comes on and off,when i press the gas the car gives a rough clicking noise and when i turn the wheel to far it cuts off. yesterday i was waiting at a light and pressed the gas the car turned off

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Check engine oil and also check electrical fuses..

Posted on Jun 30, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

95 saturn cuts out


Oh yeah. Owned a 95 SC1 for five years myself with a 1.9L I believe engine. These cars require that the ECM be set right or "else." To reset the computer, you will need to unhook both battery cables, wait about 15 minutes and rehook. See if this makes a difference in how it runs. If not, you may have dirty fuel injectors or fuel filter.

Aug 31, 2012 | Saturn SL1 Cars & Trucks

1 Answer

Rough idle on a 2000 echo when warm no check engine light


If it is an ignition miss, it should turn the check engine light on and give you a code for which cylinder.
A fuel problem or mechanical problem would not always make the warning light come on. Once the engine warms up the O2 sensor gives the computer data to cut back on fuel.
You might want to check the computer for trouble codes to see if anything has been stored.

Aug 17, 2012 | 2000 Toyota ECHO

3 Answers

1999 Lexus ES300 Steering wheel make groaning noise


Hi
If the groaning sound is still happening, you are probably low on power steering fluid. I suggest starting there. Remove the cap and check the dipstick attached to the cap. The reason the sound would go away at high speeds is that you don't turn the wheel as sharply at higher speeds so the pump is not trying to pump air ( that's the groaning sound ).
If you are low on PS fluid, fill it but check for leaks for a while. Look under the car in the morning for fluid. If you spot a leak, take it back to whomever replaced the hose and have them fix it.

As far as the engine light goes, first make sure the gas cap is on properly, meaning all the way. Turn it till you hear it click several times. If that is all it was, the light should go off after 20-30 miles or so. If it stays on, try changing the gas cap. That is probably one of the cheapest routes to go.
Good luck

Apr 12, 2009 | 1999 Lexus ES 300

3 Answers

Engine problems


go have engine light code scanned will give area to start for repair as to steering assist that can be from the low idle and rough running

May 31, 2017 | 2006 Suzuki Forenza

1 Answer

4x4 light and knocking noise after driving


If you hear the noise after the engine is turned off that noise is most likely the exhaust system cooling down. As far as the light for the 4 wheel drive that requires a test be run with a special scan tool while the problem is occurring.

Apr 20, 2017 | 1994 Jeep Grand Cherokee

1 Answer

Engine runs rough after about ten minutes /idles really low


Just trowing some suggestions out there, but, I would check the idle air control valve (solenoid) or the throttle position sensor. If they check out then my last guess would be the map sensor or the vaccuum to the map sensor. Hope I was able to help. Best wishes.

Jan 16, 2009 | 1991 Plymouth Laser

2 Answers

1996 Buick Regal, 96k miles - Recent purchase - doesn't seem right.


Will your 'friend' take it back? 1 prob, likely a vaccum leak at the intake. 2 prob, at 'stopping'?? Brake pads. Stopped, good question. 3 prob, either the plastic cover or the horn pin under the steering wheel. 4 prob, This sounds like the exhaust 02 sensor is acting up. 5 prob, shock bushings or rubbers mounts on sway bar. Or the top bearing on a strut. 6 prob, Fixing the past probs 'may' solve this? 7 prob, Just live with this! You have enough on you plate already! Frankster016

Oct 26, 2008 | 1996 Buick Regal Olympic Gold

Not finding what you are looking for?
1999 Chrysler Concorde Logo

160 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8211 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...