Trunk ajar light stay on
SOURCE: How do you turn off a tire pressure sensor dash
check the tire pressures in ALL tires not just the 4 on the ground but the sapre also. If the pressures are all correct and the light is still on you may need to take it to a tire store such as good year or firestone or eve you local dealr to have the tpms SYSTEM checked out, (TPMS Tire Pressure Monitoring System)
SOURCE: 2001 mitsubishi galant trunk problem
yes a screwdriver or pliers depending if you can see the lever from where the key fits from .just turn it or open the lock itself
SOURCE: I have a 2006 Mitsubishi Galant. The 15 amp fuse
Inspect your brake light switch that is located on your brake pedal, these little puppies are notorious for failing on these vehicles, I hope I could help, rate me accordingly, Thanks!!!
SOURCE: My 2000 mitsubishi galant trunk
Sorry my friend, I think you won't find one....The best way is to fold back the carpet and locate the end of the broken cable, and then take a pair of pliers and pull the cable from there...
When it comes to replacing the cable it would be easier to remove the front and rear seats enabling better access to the cable....Then fold back more of the carpet.
There is usually a ten millimeter nut holding down the lever.... Remove that and then remove the trunk locking mechanism....That will mean removing two additional ten mil bolts
With those removed unhook the cable from the lock....It will have a small round ball at the cable end. This can easily be removed via the slot provided.
Tape the new cable to the end of the old one....Unhook any outer cable retaining clips you find, so the the cable cannot be caught anywhere.Refit in the cable into the trunk lock mechanism, this so that the cable cannot be pulled all the way through, if you should pull too far....gently pull the cable through
Refit the lever to the floor and then refit the trunk mechanism....The rear cushion is released by pulling upwards and fitted back by locating the retaining tongues into their slots....To remove the front seat, move all the way forward to remove the bolts at the rear of the rails and then slide it back to get the front ones removed....
Sorry I couldn't help any other way....Regards Johngee10
SOURCE: After starting car check engine
Diagnosis must begin with scanning your Engine Control Module to find out why it has turned the light on. The car may seem to be running OK, but there is probably a problem that is causing you to use excessive fuel and/or is threatening to destroy some high dollar parts like your catalytic converter.
121 views
Usually answered in minutes!
×