Question about 2005 Ford F-150

1 Answer

The service light comes on and the rpms goes up and down. It will some times stall also .

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 776 Answers

Whenever the "Check Engine" light comes on, there is always a DTC (Diagnostic Trouble Code) stored in the ECM (Engine Control Module). You'll need an OBDII (On-Board-Diagnostics) scanner to retrieve any codes recorded/set in ECM. Once you do this and let us know what, if any codes are set, then we can go from there.

Posted on Jun 30, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why is My 1998 chevy astro van running so bad?power loss, sputters pops and stalls.runs better at hi rpms.and blinking service eng.lite on


Did you replace the distributor cap and rotor as well ? Has the coil been checked for signs of arcing, carbon tracking ?

Mar 09, 2015 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

My 87 buick centry stalls while driveing but when it stalls the battery light and service engine light comes on but once i put the car in park or nutrol it will start back up


My 1987 buick centry limited cuts off when i drive but when i start it back up it will start right bacc up at times some times it starts and die agin but when it dies the battery light and service engine light comes on but once it starts the service engine and battery light goes away and dont do it agine tell it cuts off agine

May 27, 2012 | 1987 Buick Century

1 Answer

Runs and stalls, wait for a min and runs again whats the problem?


well i would say if the rpm gauge stay's up and the other's all go down that would be a blown motor.

May 09, 2010 | 1999 Dodge Durango

1 Answer

2000 Isuzu Rodeo ls V6 4 wheel dr.


Check the fuel pressure it could be the fuel pump or pressure regulator.

Apr 28, 2010 | 2002 Isuzu Rodeo Sport

1 Answer

Engine stalls when put into gear , rpm goes up and down sometimes 450rpm and other times 750rpm. if it doesn't stall it runs fine.


sounds like the idle air control is either clogged with carbon or it is bad. take iac off and clean out the passage way to engine. do not put valve in any liquid, only the end of valve can be cleaned were valve is. do not push on valve while cleaning or the adjustment will be messed up.depending on the size of engine it should idle at about 650 to 700 rpms.I have a 3.1 and it idles at 650 rpms,

Jan 19, 2010 | 1994 Ford Bronco

1 Answer

My 1996 GMC jimmy wants to stall when I come to a stop. The RPM gage goes up & down then drops below 1000 RPMS and stalls.


I would go down to your local auto parts store and do an alternator and battery test. It sounds like at low rpms you are loosing volts. When you apply the brakes you would be supprised how much power from the engine it takes. You could also be loosing oil pressure. Check your oil level. When your engine drops low rpm, the oil pressure drops and shuts down the engine.

Jan 09, 2010 | 1996 GMC Jimmy

1 Answer

Truck stalls


if it is burning rich, there for it will be over fueling around low rpm i do belive, which will cause the engine to flood, im guessing after you have been low rpm then go for high rpms, it like hesitaes and takes abit of a cough then goes, if that is the case then it is overfueling.

there is a way to advance/****** the engine mixture, but id say for safe if you don't know what your doing to take it do a garage, and ask for it to be timed up with the timing strobe light :) which will stop the, over fuelling around low rpms.

Apr 10, 2009 | 1994 Toyota Pickup

Not finding what you are looking for?
2005 Ford F-150 Logo

Related Topics:

118 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

gerry bissi

Level 3 Expert

4376 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...