Question about 1994 Ford Econoline

1 Answer

92 e350 fresh tuneup, once really warm-100+mi, engine looses all power, seems to go into shut down mode, pedal to the floor just enough to make it to the station. The following day starts and runs great. This has happened twice now.?? Some say defective ecm?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 145 Answers

You may have a false contact on your Mass air flow sensor (MAF)
or a clog fuel filter.

Posted on Jun 30, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Kia sportage diesel acceleration problem


Do you have any check engine lights on? Most diesels have a safety feature that shuts down the engine and puts it in "limp mode" when there is a problem somewhere . It will stay in limp mode till repaired and the code cleared. You should get a code with a diagnostic.

May 22, 2015 | Kia Cars & Trucks

2 Answers

So I have a ford 97 e350 ambulance. I finally got the engine codes they read p0308 and p1662. Showed up at the same time. The truck ran rough, turned engine 9ff, back on, idled fine, and then a few mi utes...


cylinder 8 is missing combustion which caused the o2 code the black box will not cause a specific cylinder to miss, there fore a fuel distribution problem is evident, the injector on eight is proablly the culprit the #8 cylinder is the last cylinder to be fed a fuel, pressure test is needed to determine if the fuel pump is strong enough to deliver diesel, ambulance spend a lot of time idling causing fatigued fuel pumps

Nov 08, 2013 | Cars & Trucks

1 Answer

My 1998 E350 engine shuts down in 10-15 minutes when the airconditioner is switched on. The won't start immediately, even with a strong battery but it will start after a while. What could be the...


probly need a tuneup-change plug wires and distributer cap--------clean throttle body and idle control motor---------get a scan and data stream done as an option

Oct 18, 2011 | 2002 Ford E350

1 Answer

I have installed new rear brake shoes and new wheel cylinders on both sides. I have bled the brakes. Good pedal when engine is off...no pedal at all when engine is started. Bled brakes 4 times.


When engine is running you have a power booster in operation. Without power booster brake pedal will be heavy. With engine running, do NOT press pedal really hard. Just normal firmness. If pedal goes to floor or just too low, it needs bleeding.

Are you sure you did not run the resovior dry?
I would think would not hurt to check the correct procedure for bleeding rear brakes. Here is a YouTube video which should help. http://www.youtube.com/watch?v=8T7Qrz3zJno

The other possible issue is the master cylinder piston is not sealing well. Might be a good idea to flush it with fresh fluid, but I imagine you have already if you bled it 4 times.

The way I was taught is this. Two persons method. To prevent mess, put a flexible tube over the nipple and drain it to a jar.
Fill resovior with fresh brake fluid. get ready at the bleed nipple with a small closed end wrench, and have helper sit in driver seat. Have helper pump brake pedal (all the way to the floor if it goes there without forcing it) 5 - 8 times, then HOLD PEDAL DOWN. Slowly open the bleed nipple and close it again BEFORE the pedal is released. Helper should keep pressure on as pedal moves down when fluid is released. Repeat until there is no sputtering or bubbles indicating air comming from nipple. Check and fill the tank every couple times to prevent emptying. If it run dry, you have a big problem. You must bleed the whole system at every wheel till ALL air is out.
Hope I have helped.

Jun 22, 2011 | 1999 GMC Yukon

1 Answer

I have a problem with my 1988 Buick Century, 2.5L 4 cyl engine. I think it has to do with maybe the MAP sensor. Problem: when it's really cold outside, I can not get the engine to start unless I floor...


a bad thermostat-testit--have car scanned for bad codes--giv it a tuneup-new plug wires and distributer cap--then throttle body and idle air cleanin--get a haynes book at parts place

Apr 01, 2011 | 1988 Buick Century

2 Answers

1996 Concorde LXi 3.5/63k mi, won't cold start (in


it might be your fuel pump. I gotta tell you though you shouldn't start changing parts at random. it will become a money pit

Feb 19, 2010 | 1996 Chrysler Concorde

2 Answers

92 s-10 after engine warms wont accelerate


could be trash in fuel filter or around pickup screen in tank. While driving everything sticks to them like magnet when you shut off and it sits it all falls off to happen again when you start the vehicle again

Aug 04, 2009 | 1994 Chevrolet S-10

1 Answer

2000 GMC Jimmy 4.3 engine surging while running


HAVE YOU HAD YOU THROTTLE BODY AND OR YOUR CAM SHAFT SENSOR CHECKED OR YOUR AIR TEMP SENSOR ? IT MOST LIKELY SOUNDS LIKE YOUR AIR TEMP SENSOR IS'NT LETTING ENOUGH AIR IN OR OPENING YOUR MASS AIR FLAP ENOUGH WHEN ITS COLD OUT CAUSING THIS.

Apr 11, 2009 | 2000 Chevrolet Blazer

2 Answers

97 ford e350 brake pedal goes to the floor...


are your rear drums set up? why did you bleed the brakes. when only when you installed new pads?

Sep 11, 2008 | 2002 Ford E350

Not finding what you are looking for?
1994 Ford Econoline Logo

Related Topics:

108 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...