Question about 1999 Lexus ES 300

2 Answers

Where is Bank 2 Sensor 1 located on 99 Lexus ES 300

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 176 Answers

Bank 2 sensor 1 is the one you see when facing your exhaust manifold on the right

Posted on Jun 30, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Lexus Master
  • 14,036 Answers

Bank 2 sensor on the left front exhaust pipe.bank 1 sensor on the right of front exhaust pipe.

Posted on Jun 30, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 Lexus ES300 Bank 1, Sensor 1


Bank one should be the side next to the firewall, and sensor one is before the catalytic converter.

Feb 06, 2014 | 2002 Lexus ES 300

1 Answer

Cost to replace oxgyen sensor for 1998 lexus 300


I just had to replace one of mine and the part was $100 (Bank 1, Sensor 1) There are 4 total. This is the 3rd one that I have replaced - I have 177,000 miles on my car.

Mar 02, 2011 | 1998 Lexus ES 300

1 Answer

I have problem on lexus es 300 99 year, when i driving at 70 miles my rpm is going to 4000. My overdrive it does not work. I have check engine light and its code is knock sensor bank 2.


My Lexus es 300 most often when engine is warm will not shift in to last gear. Stop engine start it will shift ok when engine is cool. engine pings kock senores. When in gear at high speed the car runs like new?? Car run bad in hot weather. VSC light on. Red light looks a circle with red line through it comes on not always..

Sep 03, 2010 | 1999 Lexus ES 300

2 Answers

P0345 Code, where is camshaft position sensor "A" (bank 2)


The Camshaft Position Sensor (CMP) on the 4.0L 6cylinder engine is bolted to the top of the oil pump drive shaft assembly. The sensor and drive shaft assembly is located on the right side of the engine near the oil filter.

a4b74c1.jpg

Fig. 1: Component locations-ES300

a7bce64.jpg

Fig. 2: Component locations-ES300



Hope this help; remember comment and rated this. TY for using Fixya.



May 06, 2010 | 2002 Lexus ES 300

1 Answer

I have 3 codes 1) P0500 2) P0125 3) P1135 1999 Lexus RX300


The PO125 is an indication of an engine running too cold-as if the thermostat were stuck open.For some reason it often sets with the PO1135 even when the engine runs at normal temp.A scan tool will indicate exactly how hot the engine is,don't trust the dash gauge. The PO1135 is a heater circuit fault in the bank1 sensor1 air fuel ratio sensor or oxygen sensor. Bank 1 is the REAR bank on this car...that O2 sensor is not much fun.PO500 is a vehicle speed sensor fault-does the speedo work correctly?it is located in the transmission near the back of the case. once again the scan tool will read vehicle speed and can aid in further diagnosis.

Mar 30, 2010 | 1999 Lexus ES 300

1 Answer

My 1999 lexus es 300 VSC off & VSC light went on. 112,000 miles. what should I do?


take it to autozone and have the light scanned. Id almost be willing to bet its an o2 sensor, the bank 1 sensors tend to go bad around that time.

Nov 12, 2009 | 1999 Lexus ES 300

1 Answer

Where is the bank1 sensor1 on Lexus RX300? I am getting P1135 error. Confused about which sensor it is.


Bank one is the side that cylinder 1 is located. Sensor 1 is in front of the cat converter, sensor 2 is behind the converter. So Sensor 1 bank 1 is the RIGHT FRONT SENSOR.

Nov 05, 2009 | 2001 Lexus RX 300

3 Answers

Need to know where to put the oxygen sensor


you have 4 sensors. bank 1 sensor 1 - bank 1 sensor 2 - bank 2 sensor 1 - bank 2 sensor 2. it depends on which one is defective.

May 01, 2009 | 2001 Lexus Gs 300

2 Answers

92 lexus es300 knock sensor


Need to remove the upper and lower air intake manifold.  There are two knock sensors for the front and rear pistons banks.  If you plan to do this yourself it is about 1 to 2 hours.  While you are at it, there is a short coolant bypass hose sitting in the same spot, replace it.  Another problem with the knock sensor is the wire harness used to connect the two knock sensors into one connection sometimes wears out and contacts the metal on the engine causing false signals to the ECM, so replace this cable also.
Just did this last summer on my 99 ES300.  Pretty easy.
DIYr

Mar 01, 2009 | 1999 Lexus ES 300

Not finding what you are looking for?
1999 Lexus ES 300 Logo

Related Topics:

809 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

881 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...