Question about 1995 Jeep Grand Cherokee

1 Answer

My 95Grand cherokee info center says service 4 wd switch. I replaced the senror on the front top left side of the T-case, with one from a junk yard. Didn't fix my prob. should I try a brand new one from the dealer?

Posted by on

  • alexandre321 Jun 30, 2009

    I did try 4 part stores and they don't carry it. only dealer.it's 39$ i don't care about the money. But do you think this is my problem. Thanks.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 414 Answers

Junk yard electronics are always a high risk. Check you local parts store they will be cheaper than the dealer.

Posted on Jun 30, 2009

  • Stan Cather
    Stan Cather Jun 30, 2009

    Also flush the case and fill with fresh fluid.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wiper delay won't work


Sitting in your vehical, front driver's side. Look down to where your "LEFT FOOT" is. Undernealth the dashboard, just in front of the door. Their is a plastice pop-off panel cover. ON THE INSIDE PANEL IS ANOTHER WIPER DELAY MODULE. Take your "Hidden Wiper Relay" Module out an bring it to your local junk yard so you make sure it's a match...That should do it.. The module is just about the size and shape as a pack of cigarettes.. No Special Tools needed... Just a flat head screwdriver..
I had to show it to someone who worked at the junk yard because it was gone from every vehical I looked at... Plug it in your truck before you pay if you can. $15.00 dollars...
Good Luck.

Jun 25, 2014 | 1993 Jeep Grand Cherokee

Tip

Service 4 wd switch warning


If you are tired of listening to the annoying beep beep beep and watching your display flash , here is the fix
1) do not replace sensor up to $45.00
2) do not replace harness up to $200
3) do not replace vic range from $300 to $850.00
4) The fix is free and takes about 20 minutes
If you get under the unit locate the speed sensor lower left side of transfere case.Then run fingers to the top front portion of the transfere case (small hands are a bonus) you will then feel another wiring harness follow that to the connection point on transfere case on the top front.There will be a connection that is the same as the speed sensor just lift locking tab and remove.I recommend cutting the wires and silicone them for a water tight seal. To cover the male end of plug on case do the same as previous. It has no bearing on the drivetrain and will not harm anything I have several thousand miles on mine both on and offrroad.Mine is a 5.2 with 256 on the clock all wheel drive.hope this helps
Dave Jr

on Jun 19, 2008 | 1994 Jeep Grand Cherokee

1 Answer

My digital screen reads:service 4wd switch


  • The 4 wheel drive switch tells the VEC- Vehicle Information Center - weather you are in 4 high or 4 low.
  • It's on top of the transfer case between drivers side from and rear doors.
  • The VEC has been know to cause this problem to so if the switch does not fix it then the VEC might have a loose wire or be malfunctioning. The VEC plagued the Grand Cherokees for a few years.
  • This is a dealer part.
  • Also check the transfer case fluid level while there. Pull the top plug and fill it until the fluid just barely seeps out.

Regards, Tony

May 25, 2011 | 1996 Jeep Grand Cherokee

1 Answer

Dog chewed off seat belt in front and replaced with junk yard now thejunk yard replacement will no retrack out


Unfortunately the junk yard takes parts from wrecked vehicles. The other problem is sometimes these vehicles are exposed to the weather soyou may have rust etc. in the track. Spray WD-40 inside and tap lightly while trying to pull belt out.

Mar 28, 2011 | 2004 Ford F150

1 Answer

I get a message "service 4 wheel drive switch" it


You need to replace the computer for the display. I found one at the local junk yard cost me $30.00 and fixed the problem. It is the display screen computer.

Dec 29, 2010 | 1994 Jeep Grand Cherokee

2 Answers

Hinge for the front door of 1999 Jeep Cherokee


its your door stop,id do the junk yard thing first,try to get one new you get new pins and thats good.or myself,if your hady with tools you can use the passengers side to copy one cut it out drill it and pin it.

Oct 12, 2009 | 1999 Jeep Grand Cherokee

1 Answer

SERVICE 4 WD SWITCH Apears on information center screen. Where is this switch and what is it?


The switch is located on top of the tranfer case which is behind the trans. The switch is used for the transfer case to apply or disigage the input clutch under certain offroad uses. I have seen many 4wd switchs fail on those cars before.

Aug 30, 2009 | 1995 Jeep Grand Cherokee

3 Answers

What kind of oil do I put into the transfer case? Is that why the computer keeps saying check 4 wheel drive?


no, DO NOT use gear oil. The transfer case uses the same type of automatic transmission fluid that the transmission uses. Is the display saying "service 4x4 switch"? If so it is common and the 4WD indicator light switch is bad and needs replaced. It's only purpose is to tell the driver info center what 4 wheel drive mode the transfer case is in. This switch will not affect the function of the 4 wheel drive. The correct fluid for the transfer case is +4 automatic transmission fluid.

Jul 18, 2009 | 1993 Jeep Grand Cherokee

1 Answer

4 wd switch service,


Replace the 4wd switch it is located on top of the transfer case.

Jul 10, 2009 | 1995 Jeep Grand Cherokee

2 Answers

Noise in transfer case or front differential


i had the same problem.. it is the vacuum switch on the transfer case. the switch is stuck open and supplying vacuum to the vacuum diaphram under the battery box. the switch is located on the upper side of the transfer case ( not the front differential) which is located driver side of the transmission. the switch cost me about $25.00. I replaced it myself. if you do your own mechanical work you can get it done just be patient.

Oct 01, 2008 | 1999 Chevrolet S-10 Pickup

Not finding what you are looking for?
1995 Jeep Grand Cherokee Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...