Question about 1998 Chrysler Sebring

3 Answers

Spark plug location on sebring convertible

Does anyone have a picture of where the spark plugs are located on a 1998 sebring convertible jx 6 cylinder? I need to change them but cannot find them.

Posted by on

  • Anonymous Mar 13, 2014

    how do you reach rear spark plugs on 1998 sebring

×

Ad

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 410 Answers

Just follow the spark plug wires my man. Three to front (radiator side) and three to the rear (firewall) side.

Posted on Jun 30, 2009

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chrysler Master
  • 2,984 Answers

Depending on the tightness of the socket fit and the engine, carefully pull the spark plug out of the bore


Spark plug location on sebring convertible - ac34e37.jpg
Hope this helps some...best that I can find!

Posted on Jun 30, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

You will have to remove the plenum on top of the motor to get to the 3 plugs that are toward the back where the firewall is located. Basically, the 3 that you see facing the front of the car, shown in the diagram above, there are 3 more straight back under the plenum. Very poor design. Be very careful when disconnecting the wires, lines and cables that go to the plenum. Just did this on my JX. Also changed the valvecover gaskets because they oil was leaking into the spark plug sockets.

Posted on Nov 16, 2012

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The location of the map sensor on a 1996 chrysler convertible sebring jx 2.4 engine


1996 Chrysler Sebring Convertible 2.4L SFI DOHC 4cyl

The MAP Sensor is located: Under hood, center, lower engine area, passenger side of engine, mounted behind alternator

25852880-d2xccmsr3fz4kuvb3ps3pyax-1-0.jpg

Sep 06, 2015 | Chrysler Cars & Trucks

1 Answer

How do you change spark plugs in a 2008chystler


locate spark plugs, unscrew and remove them , screw in new spark plugs

Sep 01, 2014 | 2008 Chrysler Sebring

1 Answer

Where are the spark plugs located on a 98 cav 2.4 litre engine


4cyl. located on top follow spark plug wires to the spark plugs. 6 and 8 cyl. located on the sides just above the intake and exuast ports.

Apr 17, 2010 | 1998 Chevrolet Cavalier

1 Answer

Coil pack


On all four cylinder sit on top of engine toward back, follow spark plug wire from top of valve cove to coil pack. On six cylinder engine the ignition coil sit inside the distributor under the cap where the spark plug wires go.

Jan 06, 2010 | 1998 Chrysler Sebring

2 Answers

1998 chrysler sebring cranking ok getting gas but no spark


The crank sensor and if its a 2.5 the distributor These were both common problems with these cars that would cause no spark. I would try the crank sensor first It is located in the bell housing of the transmission near the engine.

Dec 27, 2009 | 1998 Chrysler Sebring

2 Answers

Diagram of where spark plugs are in 2002 sebring coupe


I own a 2002 sebring 2.7 liters engine and i can tell you where they are. on each 2 top side of the engine you will see square blocks(3 on each side) with a couple of wires coming out , they`re held in place by two nuts, these are the high voltage coils, remove the coils and you`ll find the spark plug underneath. have fun

Nov 08, 2009 | 2002 Chrysler Sebring

1 Answer

Illustration of where spark plugs go on a 2006 chrysler sebring


Easiese solution is to trace the spark plug wires to the individual locations.

Jul 28, 2009 | 2006 Chrysler Sebring

1 Answer

Not getting a spark


hello, i have a 1998 sebring, had the same problem, it was the ignition module which is located in the distributor, so i changed out that and now it starts and runs great, $215 for reman. napa

Jun 15, 2009 | 1998 Chrysler Sebring

1 Answer

Spark plug numbering


The even numbers are at the front of the car.

1 - 3 - 5
2 - 4 - 6
(front)

Aug 15, 2008 | 2003 Oldsmobile Silhouette

Not finding what you are looking for?
1998 Chrysler Sebring Logo

759 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75842 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...