SOURCE: Rear differential oil leak
You can buy the step-by-step repair manuals for this truck from your local dealer, it makes things a lot easier.
SOURCE: 94' toyota 4runner rear differential seal
1st, check to see ifthe vent is plugged on the Differental????? This will make the oil to come out when the oil heats up amd makes gases & pressure. The gases & pressure has to go somewhere!!!! Did the person put a new Crush sleeve, to take the slack out of the pinion, which will makes to pinion move from side to side. Replacing it is no problem. Just time! Gear oil, Seal, Gasket, & Crush sleeve. Place everything on the ground in the order that you take it off. Also check upper & lower bearing & races to see if they need to be replaced. This will also make slack, which will mess up your seal, and star leaking again. Good luck,and take your time.
SOURCE: oil leak problem with 1996 toyota camry
I am going to see a mechanic - my trusted mechanic who does not nickel and dime me - to see what this is. I have the same problem and he told me he has never done this job on a Camry and is unsure. Given the miles, he has suggested that maybe it is time to part ways with the car. I am going to ask him if he will put some florescent dye in it and let me drive it for 50-100 mi and then check to see where the leak is and fix it. Let you know what happens. I have to try, the car is solid.
SOURCE: I have oil leaking from my rear-right wheel. It
yes theres a seal from the axle shaft, but theres a also your brake cylinders. to find that you need to remove the tire and check the brakes or check the brake fluid reservoir for low fluid. either way you need to remove the tire. if its your axle seal then the pin theres pins on the actual differential to remove the axle shaft. a little more complicated. check the axle shaft to wear from the seal and bearings. also check the diffrential for a good level or you will loose the diffrential if you keep on running it. the level check is on a plug like half way that ususally removed by hand or a ratchet then stick your finger and if you dont feel it put oil on,. the proper oil level is when you can feel the oil with out sticking in a rod or stick in there. hope this helps
83 views
Usually answered in minutes!
×