Service tire monitor systems - Cars & Trucks

Using the Driver Information Center (DIC)
Important: After resetting, the tire pressure monitoring (TPM) system requires up to 8 km/h (5 miles) of flat, smooth road straight line driving in each of the 4 speed ranges to complete the calibration process. For further information, refer to Tire Pressure Monitor Description and Operation . If the TPM system does not reset, refer to Driver Information Center (DIC) Switch Inoperative .

1. Set all tire pressures to the recommended kPa/psi. Refer to Vehicle Certification, Tire Placard, Anti-Theft, and Service Parts ID Label .
2. Turn ON the ignition, with the engine OFF.
3. Press the vehicle information button until TIRE INFLATION MONITOR SYSTEM PRESS (down/left arrow) SWITCH TO RESET is displayed.
4. If the system is being reset due to a low tire pressure condition, press and hold the down/left arrow button until TIRE INFLATION MONITOR SYSTEM HAS BEEN RESET is displayed. If the system is being reset due to a tire rotation, press and hold the down/left arrow button for 5 seconds.
5. Release the down/left arrow button and TIRE PRESSURE NORMAL is displayed.

If the BCM detects a low tire pressure condition, a variation in pressure between 2*tires on the same axle, or a malfunction in the system, it will send a serial data message to the instrument cluster. Hope this helps!

The tire pressure monitors are made in the valve stems. You will have to replace the valve stems then have the codes cleared at the shop. Most tire stores have the tool to reset the tire pressure monitors. It can be a little costly.

You wanna shut it off Check tire pressure, Check owners manual

It means you have a malfunction in the TPMS system. First you can try to do a reset as follows: 1. key on, engine off, parking brake on. 2. turn park lights on and off 4 times you will hear a horn chirp twice, you are in program mode. Start at L/F tire release air for 10 seconds, wait 15 seconds until horn chirp, after chirp go to R/F tire do the same until horn chirp then R/R let air out til the chirp then L/R do the same after the L/R chirp, turn key off and you are done, note you have only 5 min. to complete. If you do not hear horn chirp at each tire, you will have to start from beginning. When complete, remember to add air to each tire, 35 psi is recommended.
If that does not work you probably have a bad TPMS sensor, which will have to be replaced. Some auto parts stores will test your sensors for free, so check around.

sound like two problems service tire light and check engine light.have vechicle code scan and put air in all four tires make sure put correct amount air pressure in all four tires.

one of your wheels needs air

Dear sir,
my 2007 suzuki xl7 service tire monitor system light stays on

The service tire monitor warning can come on for many reasons. A sensor may have gone bad, may have been broken if a tire was changed recently, the car needs an updated module and antenna. The system woiuld need to be looked at by a technician.

Don't know that much about these but depending on where you bought ur tires they might service them for free, I know places like big o and discount both service tires for free. My guess would be that the batteries just need changed since they're supposed to last ten years and the car is 11 yrs old.