Question about 1996 Mercury Grand Marquis

1 Answer

The brake light on the dash came on the brakes seem to work fine could it be a faulty light

Posted by on

  • Ray Keckeisen May 11, 2010

    what kind of car, model,year



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 218 Answers name is Keith..and the brake light on the dash comes on usually when the fluid is low in the brake master check the level and see if the light goes out if it needed some added....if not..write me back

Posted on Jun 30, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Dim tail light.

Brake light switch under dash and actuated by the brake pedal lever is out of adjustment or faulty. Adjust or replace it and you'll have your brake lights back. The dim tail lights may just be that you have possible replaced them with the wrong bulbs or the ground to light housing is faulty.

Jul 11, 2017 | Cars & Trucks

1 Answer

2002 suzuki xl7 makes beeping noise under the dash when applying the brakes

Top up the brake fluid and make sure the brake stop lights are all working.

Feb 03, 2018 | 2002 Suzuki XL-7

1 Answer

My brake dash light is on all the time and speedo is going haywire. any ideas?

best have vechicle pressure bleed since you have anti lock brake system.if you see brake light flashing you have brake failure either mastercylinder is faulty or still have air in brake system.let a garage fix brake system need tech 1 scanner to reset anti lock brake control module.

Jan 07, 2012 | 1990 GMC Suburban

1 Answer

Brake light on replaced rear and front brakes and before the change when the light firdt came on it made acracking sound , and the brakes still have to be pumped before the light will go off, but then it...

Brake light on dash means that it thinks the parking brake is on. If everything seems fine, then it must be the switch that turns this light on that is faulty.

Jan 14, 2010 | 1996 Jeep Cherokee

1 Answer

Tail light, brake light and battery dash light illuminate at once

check all of the body grounds.
also check the bolted positve connections the power supply.
check and clean the battery terminals.

Aug 21, 2009 | 1994 Toyota Camry

1 Answer

Brake lights don't work on 1988 Ford Thunderbird

Check the brake light switch located under the dash, connected at the junction where the master cylinder rod connects to the brake pedal. Remove the connector and with a short piece of wire, paper clip works fine, insert into the two terminals on the connector. Check to see if your brake lights are on. If they are, your switch is bad.

Jun 27, 2009 | 1988 Ford Thunderbird

1 Answer

1994 Honda Accord Brakelights (all 3)stay on even when car is off

There is a brake light switch located under the dash at the top of the arm that the brake pedal is mounted to. It either needs to be adjusted or is faulty. This switch is what makes your brake lights come on and it will do this whether the car is on or off. Most likely just needs to be adjusted so that the tip of the switch isn't touching the brake arm until you push the pedal. Its very simple to adjust

May 04, 2009 | 1994 Honda Accord

1 Answer

Dash board parking brake and ABS lights stay

you have an abs fault. have your abs system scanned for codes.

your base brakes will continue to function normally

Apr 13, 2009 | 2002 Chevrolet Suburban 2500

1 Answer

Anti lock brakes

make sure the slides on the calipers (they acuate the pads) are cleaned and the slides are lubed with a high temp brake caliper grease . the other possibility is a faulty master/brake booster

Jul 20, 2008 | 1985 Audi 5000 S

Not finding what you are looking for?
1996 Mercury Grand Marquis Logo

Related Topics:

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

gerry bissi

Level 3 Expert

4376 Answers


Level 3 Expert

81400 Answers


Level 3 Expert

5687 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides