Question about 2001 Jeep Cherokee

1 Answer

Have 2001 cherokee check engine light came on drove home parked now will not start will crank ok checked engine codes p0303 comes up any thoughts

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 396 Answers

Sounds like you have a fuel pump or distributor gas and or spark not getting to engine.

Posted on Jun 29, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

S430/102k, mi/ Wouldn't start. Told to put car in neutural and 'rock it' 'Rocked' car, put it in park and car started and 'check engine light lit'Prior to the no start, wife...


Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.


To confirm the problem, the basic troubleshooting is required.


Click this link below and follow the troubleshooting:------

http://technoanswers.blogspot.in/2012/02/car-starting-issues.html

---------

This will help.

Thanks

May 18, 2011 | Mercedes-Benz S-Class Cars & Trucks

1 Answer

Dear sirs...HELP!!!! ok we had issue w/ code P0303 and replaced plugs & wires...ran better when started up until I got ready to drive around block to test drive...idle seemed little rough when in park...


p0303 is cylinder 3 misfire. Check that plug, boot and coil. . You can move this coil and boot to another cylinder to see if the code changes. If it does, you have a bad coil or boot. Its most likely the spark plug boot on cyl 3.

May 02, 2011 | Ford Taurus Cars & Trucks

1 Answer

Car is stuck in park. Wife drove home last night


TRansmission went on the car you may have to buy a new transmission

Mar 19, 2010 | 2001 Pontiac Grand Am SE

1 Answer

1994 jeep grand cherokee laredo starting problems


Check to see if the fuel pump is running after it shuts down...could be a relay or the pump itself (overheating internally) Checked the fuel filter yet? Some crank sensors need to be shimmed. If it's too close to the flywheel even though you recently changed it, if it's too close to the wheel it can fail again. May not be the case but worth checking over. Also check the ceramic resistor on the left fender near the master cylinder if you have one. That too can cause problems.

Dec 27, 2009 | 1994 Jeep Grand Cherokee

1 Answer

Won't start went to garage started for them for one week every day then got it home on a wed. didn't use until saturday went about 5 miles came home then for two days didn't use it and went to start it and...


Have someone check for spark at the plugs,if no spark either the crank sensor or cam sensor has gone bad,and making a guess from working on these I would say the crank sensor but you should be the mil lamp "check egine light" to come on and set a fault code,this assumes the engine cranks over and fuel system is ok

Feb 27, 2009 | 1999 Jeep Cherokee

1 Answer

Wont Crnk


did ya get it goin???? havent heard from you???????

Oct 26, 2008 | 1995 Jeep Cherokee

1 Answer

1992 jeep engine problem


hello did you get your question answered?
how was the support
thanks
paul

Oct 24, 2008 | 1995 Jeep Cherokee

1 Answer

Wont Crank


It's probably one of these:

1.NSS- (Neutral Safety Switch)
2.CPS- (Crankshaft Position Sensor)

**Look here-
CPS 1/2 way down..
http://www.lunghd.com/Tech_Articles/Engine/Basic_Sensors_Diagnostics.htm

**And here-
NSS.. .
http://www.cherokee-jeep.com/1-2swremov.htm

Oct 24, 2008 | 1995 Jeep Cherokee

1 Answer

Jeep Hesitates. P0303 code


Check the cylinders Commpression. over 115 psi is good, 120 psi is normal.

Sep 17, 2008 | 2001 Jeep Grand Cherokee

Not finding what you are looking for?
2001 Jeep Cherokee Logo

Related Topics:

159 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...