Question about 1995 Chrysler Sebring

1 Answer

Downshift 95 sebring 2.5 will not shift into 3rd, will catch for a sec or two the freespin like it is in neutral then will lock into "safe-mode" until I restart it. I have replaced the input and output sensors on the tranny and the ECU/TCU computers with working replacements and still no luck. could it be the solinoid pack? or should i just pull it and rebuild?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 54 Answers

PULL AND REBUILD

Posted on Jun 30, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 95 silverado c1500 with 4l60e trans and it wont go into overdrive


overdrive is the fourth gear.D1,D2,D3,D4 now drive truck at 80 kmh
cruise at steady speed no fuel pedal movement, downshift from D4 to D3 you should feel RPM raise .. after push brake pedal a little you should see RPM raise 300 to 400 rpm.
shift pattern is 1st gear ,second gear,3rd gear and lock up(torque converter clutch). 4th gear with lock up
hope it helps

Mar 29, 2014 | 1995 Chevrolet C1500

1 Answer

95 pathfinder wont shift into 3rd gear never slipede


could be neutral safty swicth but you are defintly in limp mode that where i always start and 97 percent time finish

Jan 12, 2014 | 1995 Nissan Pathfinder

1 Answer

2003 Grand Am Automatic will shift normal from 1-2 but will not shift into 3 or 4.


Worn clutches or solenoid issues if it is an Alison style box.

Apr 02, 2017 | Pontiac Cars & Trucks

1 Answer

2005 Altima SE is missing 3rd gear


I know this is an older post but I just replaced the solenoid in my 05 altima and the same thing with 3rd gear. I was wondering what you did to fix it?

Aug 15, 2012 | 2005 Nissan Altima 3.5 SE

1 Answer

1989 pathfinder transmission 3spd w/ overdrive works great when first started, then downshifting starts way early, started after alternater wentbad


Do you mean upshifting starts way early? Going from 2nd to 3rd in other words?
Ireally don't know your transmission,but the alternator problem might've possibly spiked and hurt your shifting solenoids in the ******. don-ohio (:^)

Nov 14, 2011 | 1989 Nissan Pathfinder

1 Answer

4L 60E - 2001 k1500 will not shift into 3-4. Oil is not burn't and stifts great into1-2


  • No 3rd or 4th gear: “3-4” clutches are worn out. R&R. The car is safe to drive (in 2) until you can get it fixed.
  • Trans shifts into gear harshly, car feels sluggish off the line, No 1st, 4th or TCC lockup available, Manual 2nd, 3rd and Reverse are only available gears, CEL is on: Transmission is either in limp-home mode or has lost electrical power. If there are lots of error codes in the PCM, check the under hood fuse that powers the transmission, and if it pops again, look for a short in that circuit like an O2 sensor harness touching exhaust. Otherwise, check PCM codes for a particular fault in the transmission causing the PCM to put it in limp-home mode.
  • No 1st or 4th available; trans shifts 2nd to 3rd by itself in D or OD and locks the converter : Shift A solenoid failed. Easy fix in the pan. Or a wiring problem from PCM to trans.. or PCM.
Check to see if your transmission is in the limp mode, which would only give you 2nd, 3rd and reverse gears. No 1st or 4th gear.

Nov 19, 2009 | 2003 GMC Sierra 1500

1 Answer

95 gran marchis trany; shifting


The transmission needs to have the filter and fluid replaced.

May 02, 2009 | 1995 Mercury Grand Marquis

1 Answer

1998 Chrysler Sebring JXI V6 2.5L Transmission Problem


most likely a valve body or a shift solenoid issue, but at the very least the trans pan and valve must come out and or be replaced, those 2 parts are fairly expensive, but don't know how much and don't wish to mislead you, have the shop look at it, u can always decline the repair.

Jan 15, 2009 | 1998 Chrysler Sebring

2 Answers

1998 Chrysler Sebring JXI V6 2.5L Transmission Problem


it sounds like the transmission solenoid or possibly the transmission itself trying to go out

Jan 15, 2009 | 1998 Chrysler Sebring

1 Answer

Transmission in limp mode?


the neutral safty switch tells the comp. what gear is in. when its not working the light wont move and the car will not go threw the gears prop. the switch is nown to go out. it is located on the tranny or down under the shifter

Jan 05, 2009 | 1992 Honda Accord

Not finding what you are looking for?
1995 Chrysler Sebring Logo

Related Topics:

123 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...