Question about 2002 Jeep Grand Cherokee

1 Answer

The light on the top of the dashboard above the steering column is blinking rapidly, and I am unable to unlock the car with the fob. Tried replacing the batter in the fob, but no dice.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,392 Answers

You either have a bad fob, or a bad wireles module. Take it to the dealer to check.

Posted on Jun 29, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 ford ranger wont start theft light blinking rapidly


try locking/unlocking doors with key fob. Also try locking unlocking drivers door with key to see if system resets

Oct 18, 2015 | Ford Cars & Trucks

1 Answer

Why is there no reaction and it doesn't start?


your anti theft device is activated,you need to lock and unlock your doors a couple times with the key fob,not the key,and then you need to put the key in the ignition and start it,if you dont have your key fob,call your car dealer to get a new one,they are programmed for each car only,you cannot bypass it.

Jun 22, 2015 | Honda CRV Cars & Trucks

1 Answer

Changed rack and pinion. when turning wheel to right horns started blowing. unplugged airbags and horn stopped. drove truck for 1 day now wont start and dome light is blinking and warning lights on dash...


It sounds like you disturbed the wiring or the connector inside the lower portion (inside the cabin, under the dashboard) of the steering column. You may have also pinched wiring higher inside the steering column, up near the horn button. You'll need to track it all down & correct the wiring problems in (and around) the steering column.

Aug 04, 2014 | 2004 Dodge Ram 1500

1 Answer

Alarm keeps going off key fob wont work


definitely there's a short circuit in your wiring harness, I suggest you to check wiring harness starting from the steering column removing it's covers carefully afterwards you can inspect under the dashboard. Also check the wires starting from battery to the fuses and the main harness which goes inside to the dash board area. Definitely you will get an idea where is the fault.

Apr 16, 2014 | Citroen C8 Cars & Trucks

1 Answer

My name is Dave, any help would be much appreciated! When I turn on the left or right directional indicator from the lever on the steering column it makes a rapid blinking on the control panel, the front...


Hi, I have a couple of questions.
1. were the signals working before you replaced the brake light bulbs, and did you use the recommended bulbs?
2. Do the brake lights work now?

The brakes and signals use the same filaments, so these things are tied together.

Jul 31, 2011 | Volvo 240 Cars & Trucks

1 Answer

Just replaced the crank sensor on my chrysler cirrus 1996. the factory alarm reset itself. i had previously turned it off. cut the volume wire so lights just blink and makes clinking noise. i can start the...


Thats not a factory alarm that aftermarket. go under the steering column and remove the whole alarm set up. or better yet find a relay that is attach to the starter signal (match the color) and restore how it used to be then you should be able to crank the car , if you sucessfull have bypass the alarm then go ahead and look for its ground and just cut it. The aftermarket cuts into the ignition switch starter signal so that is where you locate the starter relay alarm.

May 22, 2011 | 1996 Chrysler Cirrus

2 Answers

How to deactivate car alarm?


I have not a car but my father has a car and i knew that m father went to the car and was stayed yto there until alarm was stoped crying

May 01, 2017 | 1998 Ford F150 Regular Cab

1 Answer

2003 ford explorer sport turn signals blink rear brake lights


The ford explorer sport track. Will have a short either at the plug of the multi-function switch or 6 inches down where the column bends the wires during tilt.

Sep 05, 2009 | 2003 Ford Explorer Sport

1 Answer

Possibly battery-related problem with '02 Mazda Protege


It sounds like the car's security system is going off. Is there a key fob to lock/unlock doors and turn on alarm? If there is, connect battery, and immediately press alarm/unlock button to turn alarm off.
I have a truck with an aftermarket alarm system installed by the previous owner, my battery died, and when I hooked up a new one the alarm went off, and it took a while before I hit the key fob button, but it stopped it. Let me know if this works for u.

Nov 19, 2008 | 2002 Mazda Protege

Not finding what you are looking for?
2002 Jeep Grand Cherokee Logo

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...