Question about 2003 Chevrolet Malibu

2 Answers

Replacing fuel pump, car turn over but want start

Replacing fuel pump

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 42 Answers

Whoa! That rear seat access doesn't exist on my '03 malibu, sure wish it did. I have that feature on my 02 Stratus, but of course the fuel pump hasn't failed on it. I recently changed the sending unit in my '03 Malibu, the classic way, jacked it up, dropped the tank and swapped it out (sounds easy but I had to cuss it several times).

Posted on Jul 03, 2009

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 22 Answers

The fuel pump should be under back seat after you remove seat lift carpet there is an access panel remove that next you should see ring that holds pump in tank spin this to remove unplug pump and replace

Posted on Jun 30, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1994 Lincoln Town Car Fuel System Failure?


Is the fuel pump relay getting power from the EEC relay when you turn the key on ? And then is the fuel pump relay sending power to the pump ?

Jun 09, 2013 | 1994 Lincoln Town Car

2 Answers

Fuel pump not always on


Did you reset the inertia switch that shuts pump down in case of collision?

Feb 18, 2012 | 2000 Mercury Grand Marquis

1 Answer

2000 mercury grand marquis 4.6 fuel


Voltage drop test the electrical circuit , do know how to do automotive electrical testing . Lose connection , resistance in the circuit , lose ground Mastering Voltage Drop Testing with Pete Meier and Jerry Truglia Testing Electric Fuel Pump Problems with Voltage Drop Test

Feb 27, 2017 | 2000 Mercury Grand Marquis

1 Answer

2000 mercury grand marquis 4.6 Intermittent problem. 35,000. miles. Problem engine died several times wile driving. Also after car is parked from a drive will not start. Found that the fuel pump is not...


I'd have to test when problem is ongoing. When you first turn on key, no crank, you should hear the pump run for a few seconds then stop. For initial prime, the computer doesn't need rpm signal. Engine cranking, the computer needs to see rpm signal or it won't ground the fuel pump relay. W/o rpm signal, no spark at the plugs and no fuel injector pulse. I know your talking about fuel, but, when problem is ongoing, check spark and fuel injector pulse, engine cranking.
Intermittent problems are a pain, have to test when problem is ongoing.
mercury fuel pump-i4kx0gxqalhdz4ok10irisui-5-0.jpg

Feb 27, 2017 | 2006 Mercury Grand Marquis

1 Answer

Car started stalling then stopped, will not start


SOUND LIKE FUEL PUMP.LISTEN FOR FUEL PUMP OPERATING BY TURN IGNITION TO THE ON POSITION.YOU SHOULD HEAR FUEL PUMP RUN FOR 3 SECONDS AND TURN OFF.IF YES REPLACE FUEL FILTER.IF YOU HEAR NO FUEL PUMP NOISE.CHECK FUEL PUMP FUSE AND RELAY.IF BOTH OKAY.CODE SCAN CAR FIRST BEFORE BUYING NEW FUEL PUMP.BECAUSE FAULT IN THE THEFT SECURITY SYSTEM AND PCM WILL DISABLE FUEL SYSTEM.

Jun 10, 2011 | 1994 Pontiac Grand Am

1 Answer

Turn key wont start- it cranks


check plug for fuel pump in harness near gas tank for corrosion and it may also have seoerated wire where it comes out of connecter the seperation may be from pulling on wires when pump replaced insulation may look alright because it streaches.

Apr 21, 2010 | 2003 Pontiac Grand Am

2 Answers

Both fuel pump relays run hot. I have replaced both of them. The truck started and ran for about 30 minutes then quit. I replaced the relays and it ran for a few minutes and quit again.


You could have a bad fuel pump relay switch. The fuel pumpmag-glass_10x10.gif relay switch gets the fuel pump running in the vehicle during the start cycle. The terms fuel pump relay and fuel pump relay switch are used interchangeably. The fuel pump relay begins its job when the automobile operator turns to the ignition on, but before the motor is actually running. At that point, the fuel pump relay in some cars sends a signal to the ignition switch, which in turn sends a signal to the fuel pump to turn on. Others fuel pump relays have actual circuitry inside of them that receive the ignition signal and directly signal the fuel pump to engage.

Have a great day!

Sep 05, 2009 | Ford F-350 Cars & Trucks

1 Answer

I have to turn the ignition on and off several times before the car starts. Recently replaced water pump after car overheated. Could coolant have caused the issue?


Replace fuel filter if it has not been done in a while. Also check fuel pump pressure with a gauge and compare with spec. When key is turned "on" the computer turns on fuel pump via relay. If the computer does not see rpm signal (engine start) within approx. 2 seconds it turns the fuel pump back off. Cycling the key often helps to build up fuel pressure sufficient to start when filter is plugged or pump pressure is weak.

Jun 29, 2009 | 1999 Ford Expedition

2 Answers

02 yukon denali xl wont start, i replaced battery, alternaor and starter are both good truck still wont start


Did you try to replace the starter cable? is the Truck turning over or just clicking.? If it's turning over and not starting. Best guess would be one of two things. Knock sensors Located under intake manifold. they get wet and deteriorate or the fuel pump. I've replaced all three on mine. 233k still running strong...

Aug 15, 2008 | 2002 GMC Yukon XL

Not finding what you are looking for?
2003 Chevrolet Malibu Logo

301 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...