Where is the location of a body control module

P240C The CAN signal for the selector lever position from component N15/5 (electronic selector lever module control module)
sounds like the GRM (Gear Recognition Module is faulty)

From the web.

Hi,

From all indications, most of your devices are controlled by a common module. This would be similar to the engine management computer but has the responsibility for all those mentioned and then some. if you would notice, most if not all are non essential to the engine's performance. Initial suspect would be such a module and/or the sensors, connectors to it. Being such as multi input and multi output, it is perhaps to your advantage to seek the services of a qualified professional. If you are considering a DIY (do-it-yourself), then access to a full service manual would make things doable if not easier.

Often this control module would be under the dash or on any of the kick panels.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards. Thank you for using FixYa.

c-class does not have a body control module. what exaclty are you troubleshooting?

VIN # ??
Engine # ??
Chassis # ??

If you need further help, reach me via phone at https://www.6ya.com/expert/ralph_2f0886b7d6af32ce

earthing issue or canbus has issues

i do not know but for the most part its on the black hose coming from the air filter to the throttle body give these websites a try www.alldatadiy.com and www.autozone.com wish you the best of luck Michigan Man.

REVERSE LIGHT PROBLEM COULD BE LOOSE WIRES OR FAULTY TRANSMISSION RANGE SENSOR.THE REAR CENTER BRAKE LIGHT COULD HAVE FAULTY BULB SOCKET OR GROUND WIRE AND THE CONTROL MODULE THAT CONTROLS IT CIRCUIT.

P1617 Control Module Fault Or Control Module Not Coded
P1630 Drive Authorization Signal

It sounds like there's an issue with your Car's computer

all oxygen sensors are located on the exhaust pipes. depending on the specific configuration, there can be 2- 4 sensors. always will be a set before the catalytic converter and a set after the cat. converter.

have yor dealer check for updated software for your transmission or engine control modules