SOURCE: 2006 ford fusion ac problem
As a Ford dealer tech I found this was always caused by the AC compressor cycling switch, it shuts the compressor off when it reaches about 30 PSI, this prevents freeze up and saves fuel, when the system press rises again to about 42 PSI it turns the compressor back on and so on, change the switch, it is located in the low pressure line from the compressor, that is the one that gets cold.
SOURCE: Ford fiesta fusion 2006-2007 the clutch starter
You would have to bypass the switch............or roll start the car.
I assume you mean the safety switch that won't allow the starter motor to go unless your foot is on the clutch.
Switch is about $ 60 ( what a rip off )
SOURCE: 2006 Ford Fusion. Left front door inside handle
This link is from the handle to the latch. The door panel has to be removed in order for this problem to be fixed. The linkage is inside the door panel, it is a small diamater metal rod called a link. If you do the job yourself be careful not to break the door panel. In a shop, the labor is 1 hour for the job & if any, parts will be a seperate charge.
SOURCE: removing alternator on a 2006 ford fusion v6
the alternator probably is accessable from the underside of the car without removing the compressor, which would require extensive knowledge and expensive equipment. the best thing to do is purchase a repair manual. this inexpensive investment has detailed procedure and pictures to help you tackle this repair.
SOURCE: my 2006 ford fusion check engine light is on and
P0882 - TCM Power Input Signal Low, this is a transmission code, I recommend that you take it to a dealer or qualified transmission shop. Hope this helps.
2,573 views
Usually answered in minutes!
×