Question about 1995 Jeep Grand Cherokee

1 Answer

Checked fan its doing fine.. put in factory recomened thermostat.. went 5miles it got to 220% took out thermostat and ran another 5 same...the top hose is soft to the touch so we are assuming the new water pump is doing its job but gages is still reading hot

Posted by on

  • honeymokey
    honeymokey May 11, 2010

    Feel for cold spots on radiator.

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 52 Answers

Do the best you can to look through the radiator with a flash light. if you can not see any light from top to bottom replace the radiator. get an aluminum one. ive had this problem myself. i changed everything before tackeling the radiator also. with no luck until i changed my radiator. remember if light wont pass neither will air.

Posted on Nov 03, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

67 mustang 200 cu that runs hot @ 220 plus


I had a 70 stang that ran hot. It had cracks in the block between the water jackets and the cylinder. It was blowing hot gas right into the water...

Jul 03, 2012 | 1966 Ford Mustang

2 Answers

The car is overheating


Check to see if the radiator is full (when engine is cold) Make sure you can hear the Thermo fans running when at normal operating temperature. If all that seems fine, replace the engine thermostat.

Nov 22, 2009 | 2007 Kia Spectra LX Sedan

2 Answers

Fine when travelling but overheats when in trafic


When the car is completely cool,check the electric fan(s) for smooth rotation.

Clean/check/change the thermo sensor,contact and wire.

===

Excavate air pocket in coolant system / check for head gasket leak

This test will kill two birds with one stone.

===

MAKE SURE THE COOLANT SYSTEM and ENGINE IS COLD!

RAN THIS TEST IN A WELL VENTILATED AREA ONLY!

You will spill some coolant during this air pocket purge test.......BE KIND TO THE ENVIRONMENT and ANIMAL please clean up after the test!

===

Put the front end on a pair of ramp or park your car on a VERY STEEP HILL (radiator facing top of the hill) .

Top of the coolant reserve tank

Let it ran for 10-15 minutes.

Monitor for air pockets escaping from coolant reserve tank.

Small amount of bubbles is OK at 1-5 minute mark

After the thermostat open up (after 195 F warm up) at
5-12 minute mark or after high idle you should see less bubbles.

If you do not see any in rush of bubbles then your thermostat may be partially stuck or rusted badly inside the thermostat hosing.

Give the thermostat host few gentle taps.

If you see larger bubbles surfacing after 15 minutes then should do a hydrocarbon (HC) dye test to test for potential head gasket leak.

Let engine cold down and top off coolant reserve tank.

Start monitor for coolant lost

===

A coolant flush is require every 2 years or 24,000 miles.

I recommend the thermostat that has a relief pop-let to reduce the change of burst radiator and coolant hoses.

Make sure you get a new thermostat gasket,black RTV and fresh coolant for the job.

===
Please post more information by clicking the comment link on the top right corner.

DON'T FORGET to RATE ME if my tip is helpful to you!

Oct 27, 2009 | 1991 Peugeot 405

2 Answers

It overheats i changed the thermostat and flushed the radiator on my 1996 cadillac


check fan operation to make sure the fan is coming on. And if it is is it at the correct temp ? If fan not coming on check relay and coolant temp switch.

Oct 20, 2009 | 1996 Cadillac DeVille

2 Answers

V6 malibu running hot no water in oil no white


check the sending unit,also when last you serviced the radiator? it may be restricted,also check the fan speed, if equip with a viscos couplier replace,

Oct 06, 2009 | 1999 Chevrolet Malibu

2 Answers

Overheats, fan doesn't run


check fuse and relay, check your coolant to make sure it isn't low, Can you jump the fan to see if the fan will work? If fan works, possibly coolant sensor.

Sep 24, 2009 | 1997 Geo Metro

6 Answers

My lincoln continental keeps running hot. I already changed the water pump and the thermostac, but it's still doing it. Help somebody.......


When the car is completely cool,check the electric fan(s) for smooth rotation.

Clean/check/change the thermo sensor,contact and wire.

===

Excavate air pocket in coolant system / check for head gasket leak

This test will kill two birds with one stone.

===

MAKE SURE THE COOLANT SYSTEM and ENGINE IS COLD!

RAN THIS TEST IN A WELL VENTILATED AREA ONLY!

You will spill some coolant during this air pocket purge test.......BE KIND TO THE ENVIRONMENT and ANIMAL please clean up after the test!

===

Put the front end on a pair of ramp or park your car on a VERY STEEP HILL (radiator facing top of the hill) .

Top of the coolant reserve tank

Let it ran for 10-15 minutes.

Monitor for air pockets escaping from coolant reserve tank.

Small amount of bubbles is OK at 1-5 minute mark

After the thermostat open up (after 195 F warm up) at
5-12 minute mark or after high idle you should see less bubbles.

If you do not see any in rush of bubbles then your thermostat may be partially stuck or rusted badly inside the thermostat hosing.

Give the thermostat host few gentle taps.

If you see larger bubbles surfacing after 15 minutes then should do a hydrocarbon (HC) dye test to test for potential head gasket leak.

Let engine cold down and top off coolant reserve tank.

Start monitor for coolant lost

===

A coolant flush is require every 2 years or 24,000 miles.

I recommend the thermostat that has a relief pop-let to reduce the change of burst radiator and coolant hoses.

Make sure you get a new thermostat gasket,black RTV and fresh coolant for the job.

===
Please post more information by clicking the comment link on the top right corner.

DON'T FORGET to RATE ME if my tip is helpful to you!

Sep 18, 2009 | 1998 Lincoln Continental

2 Answers

My e46 overheats, the fan does not come on


When the car is completely cool,check the electric fan(s) for smooth rotation.

Clean/check/change the thermo sensor,contact and wire.

===

Excavate air pocket in coolant system / check for head gasket leak

This test will kill two birds with one stone.

===

MAKE SURE THE COOLANT SYSTEM and ENGINE IS COLD!

RAN THIS TEST IN A WELL VENTILATED AREA ONLY!

You will spill some coolant during this air pocket purge test.......BE KIND TO THE ENVIRONMENT and ANIMAL please clean up after the test!

===

Put the front end on a pair of ramp or park your car on a VERY STEEP HILL (radiator facing top of the hill) .

Top of the coolant reserve tank

Let it ran for 10-15 minutes.

Monitor for air pockets escaping from coolant reserve tank.

Small amount of bubbles is OK at 1-5 minute mark

After the thermostat open up (after 195 F warm up) at
5-12 minute mark or after high idle you should see less bubbles.

If you do not see any in rush of bubbles then your thermostat may be partially stuck or rusted badly inside the thermostat hosing.

Give the thermostat host few gentle taps.

If you see larger bubbles surfacing after 15 minutes then should do a hydrocarbon (HC) dye test to test for potential head gasket leak.

Let engine cold down and top off coolant reserve tank.

Start monitor for coolant lost

===

A coolant flush is require every 2 years or 24,000 miles.

I recommend the thermostat that has a relief pop-let to reduce the change of burst radiator and coolant hoses.

Make sure you get a new thermostat gasket,black RTV and fresh coolant for the job.

===
Please post more information by clicking the comment link on the top right corner.

DON'T FORGET to RATE ME if my tip is helpful to you!

Aug 24, 2009 | 1999 BMW 318 ti

2 Answers

460 overheats


Sounds as if the head gasket is leaking compression pressures into the cooling system. It seems that this problem has just occurred recently. This can be checked at your rad shop. They have a tool that uses a chemical solution that changes color if there is any engine gases present in the coolant.

Jun 10, 2009 | 1989 Ford F 250

2 Answers

Responce for clarification


You'll only see good circulation when it's at operating temperature & hot enough for thermostat to open, allowing coolant to flow through the system. Hope you had heater on (not defrost) while you were letting it run/circulate. I usually wait for rad fan to come on 2 or 3 times, before I put cap back on. Rad fan comes on to cool what just came out of engine when thermostat opened, so when you see good flow, you'll probably see fan come on shortly after.

Apr 13, 2009 | 1995 Toyota Camry

Not finding what you are looking for?
1995 Jeep Grand Cherokee Logo

75 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...