Question about 1992 Suzuki Samurai

1 Answer

Does a ca18 motor and box fit in a zook and were does tha shifter come out

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 138 Answers

CA18 motor and box out of S13/S14 will fit into a Samurai with custom mounts.
Here's a pic of an SR20 in a Zook.. It is very similar to a CA18 only slightly bigger.
http://i121.photobucket.com/albums/o221/want33s/SR20%20Zuk/zm1.jpg
I'm not 100% sure but I think the shifter hole in the floor needs to be enlarged rearwards a bit to accomodate the nissan box.

Posted on Jul 01, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why will the gears of my actros truck not workafter fitting new clutch


well a description of the problem would be a big help
does the gear crash when the clutch is pressed in
can the gears be engaged cleanly when the engine is stopped
did you install a single plate clutch or duel plate clutch
if the gears worked properly before removing the box , then the problem will be in the clutch plate fitting ( wrong way round and the hub is hitting on the flywheel bolts or duel plate on clutch bub is incorrect hitting on the other clutch hub)or the gear shifter installation after fitting the box

Sep 13, 2014 | Mercedes-Benz Mercedes Bentz Actros Semi...

1 Answer

I connected my back up camera today n when I connect tha camera 12v wire behind my double din to tha power wire it comes up but my stereo doesn't do anything it stays in camera mode wat is my problem


There is a wire that has to be connected to the reverse switch on the transmission shifter. If this is not hooked up right you will have this problem.

Mar 20, 2014 | Cars & Trucks

1 Answer

Firing order of nissan bluebird 1992


1 3 4 2
number 1 being the cylinder closest to the front of the engine

Mar 20, 2012 | Nissan Bluebird Cars & Trucks

1 Answer

1993 jeep gc/ key turns but doesnt start, i have power on the dash but it just wont crank....is this the ignition switch or the cylinder lock?


Few thing there:
- Battery charge
- Ignition switch go to bad
- Starter go to bad
- Neutral safety switch; confirm that shifter is in P position, if not adjust this device (drivers side, gear box, under vehicle).
- Antitheft system activated; if recently tha batteri was disconnected, this is armed.

Hope helps.

Sep 24, 2011 | Jeep Grand Cherokee Cars & Trucks

1 Answer

Change valve cover gaskets on 1984 v6 2.8 litre motor


I was just wondering "How tough can this be?" So -I went out to the mini Blazer (also an 84) and gad-zooks- the air injectors , power steering, Most of the unmarked emissions lines and a fist full of wires.

So get out your camera and note pad, sticky notes and magic marker. Get an 8139 Chilton book and have at it.

May 26, 2011 | 1984 Chevrolet S-10

1 Answer

2000 Plymouth Breeze During periods of high humidity and temperatures, car loses ground and all of the following stop working: door locks, wipers, AC compressor, all gauges (odometer, speedometer, gas...


find the ground terminal of radiator fan, all those black wire togetehr w/ this, why not make a shortcut, ground to body wire 1&2 of fan, same black and tight wiper motor bolts,

Jun 21, 2010 | 2000 Plymouth Breeze

1 Answer

Hello. i have a 5002 grand prix.and tha message box keeps telling me that (reduced engine power)what does that mean


hi some vehicles are fitted with what is known as a "limp home" system, this might be a fault with the transmission, and what it is doing is reducing the power so you do not cause any damage to the motor, this will have to be put on a diagnostic system to find out what is exactly wrong, but normally it is to do with the gear selector switch...hope this helps

Jun 05, 2010 | 2005 Pontiac Grand Prix

2 Answers

My hydraulic clutch line where it meets w tha connector under the fluid box in the motor compartment broke @ the fitting..... What do I do


you will have to put a new line on plus find someone who knows how to bleed a clutch otherwise you may be replacing a clutch if you don't know what your doing.

Mar 09, 2010 | 1992 Chevrolet S-10

1 Answer

2008 chager stuck in park


shifter interlock in op /chech fuses

Aug 09, 2009 | 1995 Nissan Maxima

1 Answer

The line going into the trans from the raiditor tha line leak so much i lose a qurt of fluid a day i think its a fitting into tha trans cuz the line is loose wat should i do?


The transmission cooler lines (2) screw into a fitting on the transmission. Best to use a line wrench to tighten the fitting, lessen the chance of stripping. Hope this helps

May 11, 2009 | Oldsmobile Cutlass Supreme Cars & Trucks

Not finding what you are looking for?
1992 Suzuki Samurai Logo

Related Topics:

184 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...