Question about 1993 Chevrolet S-10 Blazer

1 Answer

My steering is loose when u turn about a inch before the wheels turn blazer s 10 4 x 4

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 109 Answers

Check tie rod ends they might be wore out when you turn the steering wheel they should move immediately with no hesitation

Posted on Jun 29, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1983 chevy S-10 blazer 4x4. The tilt steering column recently began getting loose down lower where the steering wheel tilts from. I know I need to remove the steering wheel and ignition lock and...


IF I WERE YOU I WOULD SAVE YOURSELF THE GREIF AND JUST GET A USED COLUMN MUCH EASIER.I DONT KNOW WERE YOU LIVE BUT IN FL WERE IM AT THEIR IS ALOT OF UPULL IT LOTS,AND THE AVERAGE USED ONE IS 59.00 TO 75 BUCKS.IF YOU WERE TO REPAIR THAT ONE you would NEED STEERING WHEEL PULLER AND A SPRING COMPRESSION TOOL FOR GM.

Aug 04, 2011 | Chevrolet S 10 Cars & Trucks

1 Answer

Sterring colum is very loose on my chevy s 10 blazer overall steering feels good just steering wheel is loose


LOOk on the top of the steering box in the middle there is a stud with a nut threaded onto it this is the adjustmemt for steering wheel play . Loosen the nut and take a stright head screw driver put it in the slot in the stud and turn it in . rembember you should have an inch or so free play in the steering wheel this will tighten it up then tighten the nut back down

Feb 15, 2011 | Chevrolet Chevy Cars & Trucks

2 Answers

Stiff steering wheel upon start up


Check your serpintine belt for cracks, & dryness. Also if wet the steering will not operate easily neither

Mar 18, 2010 | 1995 Pontiac Sunfire

1 Answer

Steering column loose and causes auto to stall and jump out of gear when steering wheel moves.


There are 3 tilt colum screws deep inside the colum, it's common for them to come loose and eventually cause wiring problems. special tools are required to thighten the torx head screws.

Used colums for that year are cheap however.

Kiwi

Jan 29, 2010 | 1986 Chevrolet S-10 Blazer

1 Answer

I have a 1989 chevy K-5 blazer, and sometimes when turning I go to straighten the wheel and they dont respond right away. Causing me to over steer in the other direction. Is this in the steering box?


Check your steering kuckle located above gear box on shaft that goes to steering wheel, while some one turn's wheel a little back & forth and check for slack, Also check front end linkage for looseness, don't forget wheel bearings.

Nov 20, 2009 | 1989 Chevrolet S-10 Blazer

3 Answers

How replace turn signal switch 2000 chevy blazer?


Since the 2000 chevy blazer is equipped with SRS (Saftey Restraint System), ie: Airbags, which is located in the steering wheel. In order to replace the turn signal switch you must remove the steering wheel. Therefore I would only highly advise you to take it to a dealer to have this done.

Oct 07, 2009 | 2000 Chevrolet Blazer

1 Answer

Loose steering wheel 1995 caprice


Replace the steering box - check junkyard for one of similar model/year or ask Pep Boys to help by cross ref. your make/yr with others. Pep Boys will even install for you.

Mar 26, 2009 | 1995 Chevrolet Caprice

1 Answer

Steering coloum loose on 1991 chevy s10 blazer


they make a tool to push the plate down you can get at autozone

Oct 21, 2008 | 1991 Chevrolet S-10 Blazer

1 Answer

Lights


hi there, its not likely the switches to go out at the same time. it sounds to me that the wiring harness under the dash by the steering wheel is loose and also check the fuses and relays in the fuse box

Aug 28, 2008 | 1993 Chevrolet S-10 Blazer

Not finding what you are looking for?
1993 Chevrolet S-10 Blazer Logo

Related Topics:

181 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...