SOURCE: remove the camshaft position sensor from my 1999 jeepcherokee
The Camshaft Position Sensor (CMP) on the 4.7L V - 8 engine is bolted to the front side of the right cylinder head. Disconnect the sensors connector. Take out the bolt that holds the sensor in place. Lightly pry out the sensor being careful not to break it. Clean out the hole and install the new sensor( put a little oil on the new sensors o-ring to help installation).
SOURCE: Need to replace TPS on 2004 Jeep Grand Cherokee 6cyl
it will be located on the throttle body
SOURCE: location of crankshaft position sensor Jeep grand cherokee 1997
left rear of engine block,on transmission bell housing.best way from top under brake booster use a wrench,
SOURCE: Jeep is giving a code of p0340 which is telling me
go to autozones website they have free diagrams
SOURCE: Where is the camshaft sensor located on my 99 Jeep Grand Cherokee
If you still have a cap rotor and ignition wires, it's inside the distributor. If not, it is the part where the distributor used to be (center rear of the engine behind the intake manifold)
Fig. 5: Remove the throttle position sensor retainers...
Fig. 6: ...then, remove the throttle position sensor
Additionally, its possible that you are interesting in some section about this repair manual: Jeep Grand Cherokee 1993-1998 (ZJ Series).
Hope this helps; just keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment. Thank you for using FixYa.
Jose.
72 views
Usually answered in minutes!
×